User manual PANASONIC KX-TG2344B

[. . . ] 2. 4 GHz Multi-Handset Digital Cordless Phone Operating Instructions Model No. KX-TG2344 Pulse-or-tone dialing capability The unit is Caller ID compatible. To display the caller's name and phone number, you must subscribe to Caller ID service. PLEASE READ BEFORE USE AND SAVE. Charge the battery for 6 hours before initial use. Panasonic World Wide Web address: http://www. panasonic. com for customers in the USA or Puerto Rico Thank you for purchasing your new Panasonic cordless telephone. Please read the IMPORTANT SAFETY INSTRUCTIONS on page 74 before use. [. . . ] Move closer to base, try again. " is displayed even when using the handset near the base unit, the handset may have lost communication with the base unit. You need to re-register the handset to the base unit. · Make sure the base unit is not being used. · Have both handsets and base unit nearby during registration. · Follow steps 1 and 2 listed below. You have about 1 minute to complete them. · Confirm the extension number of the handset which has lost the communication by placing the handset on the base unit or charger. If you re-register the handset using the other handset's extension number [ ] or [ ], the other handset will not function. 1 Base unit: To re-register the handset 1, press and hold LOCATOR/INTERCOM [ ] until a beep sounds. To re-register the handset 2, press and hold LOCATOR/INTERCOM [ ] until a beep sounds. · The CHARGE indicator flashes. 2 Handset: Press and hold [FLASH/CALL WAIT] until "Handset Registering" is displayed. · When registration is complete, a beep sounds from the handset and the display shows the number. · Wait for 20 seconds after registration is complete while the handset establishes communication with the base unit. Handset Registering Ex. Extension number 1 Handset [1] Registered · If the handset beeps 3 times and "Error!!" is displayed, an error occurred. · You can stop registration by pressing [OFF] on the handset, and pressing LOCATOR/INTERCOM [ ] or [ ] on the base unit. 48 Automatic Answering Operation When the unit answers a call, a greeting message is played and the caller's message is recorded. · The total recording time of all messages (greeting and incoming) is about 15 minutes. If messages are recorded in noisy rooms, the time may be shortened by up to 3 minutes. · To select the caller's recording time, see page 20. · A maximum of 64 messages (including greeting message) can be recorded. Setting the Unit to Answer Calls Base Unit Press [ANSWER ON] to turn on the Answering System. · The indicator lights and the unit announces "Answer set" and current day and time. Set time" is heard, set the date and time (p. · The unit will announce the remaining recording time if it is less than 3 minutes. · When no recording time is available, you will need to erase any unnecessary messages before new messages can be recorded (p. [ANSWER ON] and Indicator The unit can indicate that memory is full in the following ways: -- " FULL " will flash on the base unit and the ANSWER ON indicator will flash rapidly until you erase a message. -- The unit will announce "Memory full" when you press [ANSWER ON] or [GREETING REC], and after playing back messages or recording a message. · If you do not want the unit to answer calls, press [ANSWER ON] again to turn off the Answering System. [. . . ] THERE ARE NO EXPRESS WARRANTIES EXCEPT AS LISTED UNDER "LIMITED WARRANTY COVERAGE". THE WARRANTOR IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS LIMITED WARRANTY. (As examples, this excludes damages for lost time, lost calls or messages, cost of having someone remove or re-install an installed unit if applicable, travel to and from the servicer. The items listed are not exclusive, but are for illustration only. ) ALL EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY, ARE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY. 81 Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the exclusions may not apply to you. [. . . ]