User manual PANASONIC KX-TGA273S

[. . . ] 2. 4GHz Expandable Cordless Handset Operating Instructions Model No. KX-TGA273S Pulse-or-tone dialing capability The KX-TGA273S will only work with the Panasonic cordless phone systems: KX-TG2700/KX-TG2720/ KX-TG2730/KX-TG2740/ KX-TG2750/KX-TG2770/ KX-FPG381 PLEASE READ BEFORE USE AND SAVE. Charge the battery for about 15 hours before initial use. 1 2 3 4 5 6 Contents by Section Getting Started Listening to the Radio Using the Sleep Timer Using the Alarms Things You Should Know Referencia rápida Panasonic World Wide Web address: http://www. panasonic. com for customers in the USA or Puerto Rico Attach your purchase receipt here. For product service ·Call 1-800-211-PANA(7262) for the location of an authorized servicenter. ·Panasonic's e-mail address for customer inquiries: consumerproducts@panasonic. com for customers in the USA or Puerto Rico ONLY When you ship the product ·Carefully pack your unit, preferably in the original carton. ·Attach a letter, detailing the symptom, to the outside of the carton. Symptom · Send the unit to an authorized servicenter, prepaid and adequately insured. · Do not send your unit to the Panasonic Consumer Electronics Company listed below or to executive or regional sales offices. [. . . ] To order, call the accessories telephone number in section 1-A. 5-C FCC and Other Information WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO EMERGENCY NUMBERS: 1)Remain on the line and briefly explain to the dispatcher the reason for the call. 2)Perform such activities in the off-peak hours, such as early morning or late evenings. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this phone. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Operating near 2. 4GHz electrical appliances may cause interference. Move away from the electrical appliances. CAUTION: To comply with FCC RF exposure requirements, the handset should be carried with the specific belt-clip provided for the handset to ensure compliance. Other non-tested belt-clips or similar bodyworn accessories may not comply, therefore, should be avoided. This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 68. 316. When you hold the phone to your ear, noise might be heard in your Hearing Aid. Some Hearing Aids are not adequately shielded from external RF (radio frequency) energy. If noise occurs, use an optional headset accessory or the speakerphone option (if applicable) when using this phone. [. . . ] · Manteniendo presionado [­] o [+] se reduce o se aumenta la hora más rápidamente. Para cambiar el intervalo de sintonización de FM Se puede cambiar el modo de búsqueda de estaciones FM de 0. 2 MHz (preconfiguración de fábrica) a 0. 1 MHz. ·Tenga en cuenta que al cambiar el intervalo de sintonización se borrarán todas las estaciones FM presintonizadas, así como la estación que usted ha asignado a la alarma de radio (6-D), y que la configuración de alarma de radio se cambiará a alarma de timbre. Presione [AM/FM, RADIO] para encender la radio. Presione [AM/FM, RADIO] para cambiar a la banda de FM. [. . . ]