User manual PANASONIC KX-CAP150

[. . . ] Read and understand all instructions. Caller ID, Call Waiting and Voice Mail Service, where available, are telephone company services. After subscribing to Caller ID this phone will display a caller's name and phone number. Call Waiting Caller ID, which displays a second caller's name and phone number while the user is on another call, requires a subscription to both Caller ID and Call Waiting with Caller ID Services (CWID). After subscribing to Voice Mail Service, this unit will give you visual indication to let you know when there are messages in the mailbox. Attach your purchase receipt here. Accessories (included) For extra orders, call 1-800-332-5368. [. . . ] · The handset will ring for 1 minute. · To stop paging, press [SP-PHONE] or [LOCATOR/INTERCOM]. Advanced Operation 2 When the paged party answers, talk into the MIC. 3 To disconnect the intercom, press [SP-PHONE] or [LOCATOR/INTERCOM]. · The indicator light goes out. During an intercom call: · If you have difficulty hearing while using the handset speakerphone and base unit speaker, decrease the speaker volume by pressing VOLUME [<] on the base unit or [d] on the handset. · If an incoming call is being received, you will hear two tones (incoming call tone, page 48) and the IN USE indicator will flash rapidly on the base unit. To answer the call; -- if using the handset, press [OFF], then [C] or [s]. -- if using the base unit, press [SP-PHONE] twice. For assistance, please call: 1-800-211-PANA(7262) 37 Intercom Answering Intercom Calls Handset When the handset is paged, it rings and the Ringer/Message Alert indicator flashes rapidly. 1 Press [C], [s] or [HOLD/INTERCOM]. · You can also answer a call by pressing any button except [d], [B] or [OFF]. Call from Base 2 To disconnect the intercom, press [OFF]. Base Unit When the base unit is being paged, it rings. 1 Press [SP-PHONE] or [LOCATOR/INTERCOM]. 2 To disconnect the intercom, press [SP-PHONE] or [LOCATOR/INTERCOM]. · When the ringer volume is turned off (p. 15, 16), the handset and the base unit will ring at the low level for intercom calls. · You cannot change the ringer tone for intercom calls. 38 Transferring a Call You can transfer an outside call to the base unit or the handset. From the Handset to the Base Unit 1 Handset: (1) During a call, press [HOLD/INTERCOM]. · The call is put on hold. Transfer to KBase Hold Calling Base (2) Press Base. access" or by pressing [VM] on the base unit. Storing a Voice Mail Access Number Handset 1 Press [MENU]. 2 Scroll to "Initial setting" by pressing [d] or [B], then press Select. Initial setting Voice Mail KBack dB SelectL 3 Press Select at "Voice Mail". 4 Press Select at "Store VM access#". 5 Enter your access number, up to 32 digits. · If a pause is required for dialing, press P*. · Each time you press f, a digit is erased. To erase all of the digits, press and hold f. KBack dB SelectL Store VM access# KBack dB SelectL Example 1234567PPP890| Kf MENU=Save PL 6 Press [MENU] to save your setting, then press [OFF]. *To prevent misdialing, you may add pauses between your voice mail access number and your mailbox password in step 5. 1-222-333-4444 PPPP 8888 Your voice mail access number Pauses Your mailbox password Pressing P once creates a 3. 5 second delay and counts as one digit. The delay time necessary between entering your access number and entering your mailbox password will depend on your telephone company. To erase a stored voice mail access number Repeat steps 1 to 4, then press and hold f until all of the digits are erased. Press [MENU], then press [OFF]. 42 Voice Mail Service Setting Voice Mail (VM) Tone Detection Handset Your telephone company sends special signals (Voice mail tones) to the unit. Press [C], [s] or [SP-PHONE] to listen to the dial tone. If you hear a series of dial tones followed by a continuous dial tone, this indicates that a new message was recorded. [. . . ] For Limited Warranty service for headsets if a headset is included with this product please call Panasonic Call Center at 1-800-211-PANA (7262). When shipping the unit carefully pack, include all accessories, and send it prepaid, adequately insured and preferably in the original carton. Include a letter detailing the complaint and provide a day time phone number where you can be reached. IF REPAIR IS NEEDED DURING THE LIMITED WARRANTY PERIOD THE PURCHASER WILL BE REQUIRED TO FURNISH A SALES RECEIPT/PROOF OF PURCHASE INDICATING DATE OF PURCHASE, AMOUNT PAID AND PLACE OF PURCHASE. [. . . ]