User manual PANASONIC KX-FM220

[. . . ] Ensure that the AC outlet is located near the PBX, and is easily accessible. This equipment should only be used with AC Adaptor PSLP1380Z. The Power Module is designed for internal use only and should be located in close proximity to the main PBX. Wherever possible, it should share any power failure backup systems provided for the PBX. [. . . ] Connect to the Doorphone's terminal block. Secure the Unit to the wall using the appropriate screws (not supplied). Re-connect the front panel to the back unit using the supplied 10 mm (3/8") M3 threaded screws. To flush-mount the Panasonic KX-FM220 Doorphone: 1. Separate the Doorphone Unit into two halves. Adjust the sensitivity of the Doorphone's microphone, if required (see page 11). Attach the gasket to the rear of the interface bracket, as shown in Figure 8. Gang-box only: Attach the interface bracket to the gang-box using screws (not supplied) (see Figure 9). Recessed only: Attach the interface bracket to the wall using the appropriate screws (this is dependent on the surface structure) (see Figure 10). Refer to the mounting template, on page 15, for drilling positions. Rear View Figure 8 Figure 9 9 5. Feed the wires through the center of the interface bracket and connect the wires to the Doorphone Module. Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product. 12 To reduce the risk of electric shock, do not disassemble this product, but take it to a qualified person when service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the appliance is subsequently used. This unit should be kept free of dust, moisture, high temperatures (more than 50°C (122°F)) and vibration. The socket-outlet shall be installed near the equipment and shall be easily accessible. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: When the power supply cord or plug is damaged or frayed. If liquid has been spilled into the product. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions because improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation. [. . . ] Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Any changes or modifications made to this product not expressly approved by Panasonic Communications Co. [. . . ]