User manual PANASONIC KX-FPG175

[. . . ] To use this feature, you must subscribe to the appropriate service offered by your service provider. Charge the handset battery for 7 hours before initial use. Please read these Operating Instructions before using the unit and save for future reference. For assistance, visit our website: http://www. panasonic. com/phonehelp for customers in the U. S. A. [. . . ] To access the features, there are 2 methods: scrolling through the display menus (page 32) or using the direct commands (page 33). L Mainly the direct command method is used in these operating instructions. Programming by scrolling through the display menus 1 2 {MENU} Press {^} or {V} to select the desired menu. i {Select} L If there are sub-menu(s), press {^} or {V} to select the desired item. i {Select} Example: To access the handset ringer tone setting Press {^} or {V} to select "Ringer setting". i {Select} Then press {^} or {V} to select "Ringer tone". i {Select} Press {^} or {V} to select the desired setting. L This step may vary depending on the feature being programmed. {Save} i {OFF} Sub-menu 1 ­ Ringer volume Ringer tone Ring color Sub-menu 2 ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ Page page 38 ­ ­ ­ page 18 ­ page 26 page 26 ­ page 35 3 4 Main menu Message play Ringer setting Date and time*1 Voice enhancer Copy phonebook *2 ­ ­ Copy 1 item Copy all items ­ ­ Talking CallerID Customer support 32 For assistance, please visit http://www. panasonic. com/phonehelp Programming Main menu Initial setting Sub-menu 1 Set answering Sub-menu 2 Ring count *1 *1 Page page 41 page 42 page 41 page 42 ­ ­ page 20 ­ ­ *1 Recording time Remote code*1 Message alert LCD contrast Key tone Auto talk Caller ID edit Time adjustment Set tel line *1 ­ ­ ­ ­ ­ ­ Set dial mode Set flash time*1 Set line mode *1 *1 page 18 ­ ­ ­ page 46 page 18 Set base unit Registration Change language Talking CallerID ­ ­ *1 If you program these settings using one of the handsets, you do not need to program the same item using another handset (KX-TG5672/KX-TG5673). *2 KX-TG5672/KX-TG5673 Programming using the direct commands 1 2 3 4 {MENU} Enter the desired feature code. L This step may vary depending on the feature being programmed. {Save} i {OFF} Note: L In the following table: ­ < > shows the default setting. L If the message memory becomes full, the ANSWER ON indicator flashes rapidly (if the answering system is turned on). L If less than 3 minutes of recording time is available, the unit announces the remaining recording time when operating the answering system. Erase unnecessary messages (page 37). Recording your greeting message You can record your own greeting message (max. 2 minutes) that is played when the answering system answers a call. If you do not record a greeting message, a prerecorded greeting message is used. Turning the answering system on/off Press {ANSWER ON} to turn on/off the answering system. L When the answering system is turned on, the ANSWER ON indicator lights. L When the answering system is turned off, the ANSWER ON indicator turns off. 1 2 3 {GREETING REC} Within 10 seconds, press {GREETING REC} again. After the base unit beeps, speak clearly about 20 cm (8 inches) away from the MIC. 36 For assistance, please visit http://www. panasonic. com/phonehelp Answering System 4 To stop recording, press {STOP}. Playing back the greeting message Press {GREETING CHECK}. Erasing your greeting message Press {GREETING CHECK}, and then press {ERASE} while your greeting message is playing. Listening to messages using the base unit When new messages have been recorded, the MESSAGE indicator on the base unit flashes. L When you have no new messages, the unit plays back all messages. Adjusting the speaker volume Press {^} or {V} repeatedly while listening to a message. [. . . ] This Limited Warranty excludes both parts and labor for batteries, antennas, and cosmetic parts (cabinet). This Limited Warranty only applies to products purchased and serviced in the United States or Puerto Rico. This Limited Warranty is extended only to the original purchaser and only covers products purchased as new. Mail-In Service For assistance in the continental U. S. A. in obtaining repairs please ship the product prepaid to: Panasonic Services Company Customer Servicenter 4900 George McVay Drive Suite B Door #12 McAllen, TX 78503 For assistance in Puerto Rico call Panasonic Puerto Rico, Inc. [. . . ]