User manual PANASONIC KX-G5500

[. . . ] 39 Answering System Answering system . 41 Turning the answering system on/off 41 Greeting message . 42 Listening to messages using the base unit . 42 Listening to messages using the handset. [. . . ] L When the unit receives a call from a number that is stored in the bar call list, the call is disconnected and the number is logged in the caller list (page 35) with 7. 4 Set which handsets to be restricted by pressing the desired handset number. L All the registered handset numbers are displayed. L Flashing numbers indicate call restriction is turned on for the corresponding handset. L To turn call restriction off for a handset, press the number again. The number stops flashing. 5M 6 {V}/{^}: Select a memory location. iM 7 Enter the phone number or area code to be restricted (8 digits max. ). 01289 8333 TG8321E(e-e). book Page 31 Monday, March 3, 2008 2:33 PM Programming Storing unwanted callers from the caller list Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to a single base unit. Important: L The additional handset model recommended for use with this unit is noted on page 5. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. Additional base units Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when "Auto" is selected on base unit (page 32), it looks for another base unit to make or receive calls. A base unit and the handsets it communicates with is called a "radio cell". Setting the repeater mode 6 {ih} Cancelling a base unit A handset can cancel a base unit that it is registered to. This allows the base unit to end its wireless connection with the system. 1 K (centre of joystick) i !i M 2 {V}/{^}: "Repeater Mode" i M 3 {V}/{^}: Select the desired setting. i M i {ih} Note: L After turning the repeater mode on or off, w flashes on the handset momentarily. This is normal and the handset can be used once w stops flashing. 1 K (centre of joystick) i N i M 2 {V}/{^}: "Registration" i M 3 {3}{3}{5} 4 {V}/{^}: "Cancel Base" i M 5 Select the base unit(s) you want to cancel by pressing the desired base unit number. i M L The selected base unit number(s) flashes. L To cancel a selected base unit number, press the number again. The number stops flashing. 6 {V}/{^}: "Yes" i M i {ih} Note: L To register a handset to another base unit or to the same base unit again, see page 32. Increasing the range of the base unit You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Contact your Panasonic dealer for details. Important: L Before registering the repeater to this base unit, you must turn the repeater mode on. L Do not use more than one repeater at a time. [. . . ] 5. 4 W Operating conditions: 5 °C­40 °C, 20 %­80 % relative air humidity (dry) Dimensions: Base unit: Approx. 48 mm × 99 mm × 155 mm Handset: Approx. 149 mm × 48 mm × 34 mm Charger*1: Approx. 51 mm × 75 mm × 88 mm Mass (weight): Base unit: Approx. [. . . ]