User manual PANASONIC KX-HCM230

[. . . ] Network Camera Operating Instructions Model No. KX-HCM230 Please read this manual before using and save this manual for future reference. Panasonic Network Camera Site: http://www. panasonic. com/netcam for customers in the USA or Puerto Rico Operating Instructions Introduction Thank you for purchasing a Panasonic Network Camera. Check the following items when unpacking. Network Camera Operating Instructions Getting Started AC Adaptor Flexible Stand Sunshade Setup CD-ROM Rubber Cap Putties Self Bonding tape Connector Cover Screws Screws for Flexible Stand For operation assistance: Call 1-800-272-7033 Refer to the Panasonic Network Camera Site http://www. panasonic. com/netcam -- 1 pc. [. . . ] (default) Favor Motion: Image is optimized for enhanced motion display. Image Quality Refresh Interval The refresh interval of JPEG - Regularly Refresh can be selected. 10 seconds to 5 minutes Limit time of Continuous Motion JPEG To make the network traffic smooth, select the duration time to display Motion JPEG. When the timer expires, the image changes to JPEG - Regularly Refresh. 10 seconds to Unlimited On the Air time Specifies the timetable to allow users to access Top View Image screen. When you access the image except the specified time, blue screen appears. Always: Always allows users to access. Operational between: Specifies the date and time to access the image. [For assistance, please call: 1-800-272-7033] 65 Operating Instructions 3. 5. 7 Image Transfer Image Transfer window can set the Image Transfer feature. Network Camera can buffer images and send the images via e-mail or FTP. The request to send the image is initiated by a contact closure from the external sensors/devices connected to the External I/O using the Alarm mode. The external sensors/ devices are customer provided. The images can also be sent in the interval of time using the Timer mode. Make sure Date and Time has been configured. Note When you use FTP or e-mail in transferring the image, you need to set Default Gateway and DNS Server address. Non Transfer : Image Transfer feature is not in use. Alarm mode Timer mode : The alarm trigger activates transferring the image. : The timer trigger activates transferring the image. Refer to page 74. Note The Alarm and Timer mode cannot be set at the same time. 66 Operating Instructions Non Transfer mode Non Transfer mode enables [Start Capture] on the operation bar to buffer the image on the Single Camera screen. Capture Control can lock [Start Capture] on the operation bar to prevent the user from capturing the Buffered Image. Click [Clear Buffered images] to clear the buffered image. [Clear Buffered images] does not save the parameters. 1. Click [Image Transfer] on Setup Page. 2. Select the each parameter. Click [Cancel] to quit the current settings. The window returns to Setup Page without saving the parameters. [For assistance, please call: 1-800-272-7033] 67 Operating Instructions Transfer in the Alarm Mode The Alarm mode can transfer an image via e-mail or FTP when the alarm trigger is active. To activate the alarm trigger, the External Sensor Input of External I/O must be connected with the external sensors/devices. [. . . ] Allow 10 cm (4 inches) clearance around the unit for proper ventilation. Avoid excessive smoke, dust, mechanical vibration, shock, or direct sunlight. Routine care: Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive powder. [. . . ]