User manual PANASONIC KXHNC600

[. . . ] This document explains how to install the outdoor camera properly. For details about how to use the system, refer to the User’s Guide (page 26). Please read this document before using the unit and save it for future reference. For assistance, visit our Web site: www. [. . . ] R Do not install the camera in areas directly exposed to water or rain. R Holes must be made in the wall for cables and wires to pass through. Panasonic takes no responsibility for issues related to opening holes in walls. R Make sure to waterproof the holes you make in the wall. R Make sure you attach the safety wire to prevent the camera from falling. ) R Mount the camera on the stable location where the unit can be adequately supported when installing. r The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected. R Do not mount the camera on a soft material. It may fall down, break or cause injury. Wall material information Siding R Use the included screws ø4 mm ´ 25 mm (ø5/32 inches ´ 1 inch). Make sure the pull-out capacity of each screw is at least 294 N (30 kgf). R If the weight of the camera is supported by the siding only, the siding could become damaged. Make sure you mount the camera in a location where the structure behind the siding can be used to support the weight of the camera. If this is not possible due to the thickness of the siding, use commercially-available screws ø4 mm ´ longer than 25 mm (ø5/32 inches ´ longer than 1 inch). R Drill a pilot hole using a drill bit that is appropriate for the type of siding. Remove any debris after drilling the pilot hole. Do not drill the pilot hole into the structure behind the siding. Poor example No support behind exterior surface 2 1 1 Siding 2 Open space, no support For assistance, please visit www. Com/support 17 Setup Ideal example Structure supports exterior surface 4 2 Insert the screw and tighten it. 2 2 Camera mounting stand ALC (autoclaved lightweight cellular concrete) 1 1 Siding 2 Structure behind siding Concrete R Do not use the included screws. Use screw anchors (screw ø: 4 mm (5/32 inches)) designed for concrete walls. [. . . ] Mail-In Service--Online Online Repair Request To submit a new repair request and for quick repair status visit our Web Site at www. Com/repair When shipping the unit carefully pack in a padded shipping carton, include all accessories, and send it prepaid. Include a letter detailing the complaint, a return address and provide a day time phone number where you can be reached. Keep the tracking number for your records. [. . . ]