User manual PANASONIC KXHNK102

[. . . ] This document explains how to operate the keychain remote properly. For details about how to use the system, refer to the User’s Guide (page 12). Please read this document before using the unit and save it for future reference. For assistance, please contact us at 1-800-272-7033 or visit our Web site: http://shop. [. . . ] Dispose of used batteries according to the instructions. Routine care R Wipe the outer surface of the product with a soft moist cloth. R Do not use benzine, thinner, or any abrasive powder. Pdf 7 2015/06/19 20:30:06 Setup LED indicator Part names and functions n Front view (Arm: Away) button Arms the alarm system using the [Arm: Away] mode. (disarm) button Disarms the alarm system. (smart) button Used to turn on a smart plug, trigger the alarm system, etc. Battery cover lock Battery cover M N Used to register the keychain remote to the hub. Key ring eyelet Key ring A B C D LED indicator You can use the LED indicator to confirm the remote’s status. N Rear view Indicator Off Amber, blinking quickly Red, lit G Status Normal operation or no power*1 Signal is being sent to the hub (you are pressing a button)*2 [Arm: Away] mode selected (you pressed the arm button)*2 [Disarm] mode selected (you pressed the disarm button), or you pressed the smart button*2 E F Green, lit H I 8 For assistance, please visit http://shop. Pdf 8 2015/06/19 20:30:06 Setup Indicator Red, blinking Status Remote is out of range of the hub, or could not communicate with the hub Registration mode (you pressed and held M N) Low battery 4 Confirm the usage area Read the information in this document to confirm that the desired usage area is suitable to proper operation. Green, blinking slowly Repeating pattern of blinking green and blinking red *1 *2 The LED lights for about 2 seconds after a button is pressed, then turns off. If the LED indicator does not light when you press a button, the battery must be replaced. The LED indicator does not indicate remote’s status if the remote has not been registered (page 11). Setup overview 1 Initial setup Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub. insert the battery The remote is battery powered. Registration Required only if the remote was purchased separately (i. R Using a metal object to open the lock may scratch the lock. R Insert a thin, flat object into the battery cover lock and rotate it to the “unlocked” position, as shown below. 3 Attach and lock the battery cover. R After attaching the battery cover, rotate the lock to the “locked” position. Attaching the key ring Attach the key ring to the remote as shown. [. . . ] For the hearing or speech impaired TTY: 1- 877-833-8855 As of June 2015 For assistance, please visit http://shop. ) Panasonic Products Limited Warranty Limited Warranty Coverage (For USA Only) If your product does not work properly because of a defect in materials or workmanship, Panasonic Corporation of North America (referred to as “the warrantor”) will, for the length of the period indicated on the chart below, which starts with the date of original purchase (“warranty period”), at its option either (a) repair your product with new or refurbished parts, (b) replace it with a new or a refurbished equivalent value product, or (c) refund your purchase price. The decision to repair, replace or refund will be made by the warrantor. Product or Part Name Home Network System Products microSD card (Included model only) Parts One (1) Year 90 days Labor One (1) Year N/A During the “Labor” warranty period there will be no charge for labor. [. . . ]