User manual PANASONIC KXHNS101

[. . . ] This document explains how to install the window/door sensor properly. For details about how to use the system, refer to the User’s Guide (page 17). Please read this document before using the unit and save it for future reference. For assistance, visit our Web site: www. [. . . ] , not as part of a bundle), you must register each device to the hub. You can register each device by using the registration buttons or the [Home Network] app. R Lift from the indented area (A) and open the sensor unit cover (B). Window/door sensor: Remove the sensor unit cover and press and hold M N until the LED indicator blinks in green (page 8). R When registration is complete, the hub sounds one long beep. Note: N R To cancel registration, press M on the hub and on the window/door sensor. R If registration fails, the hub sounds several short beeps. Using the app When you register the window/door sensor by using the [Home Network] app, you can assign a name to your For assistance, please visit www. For more information, refer to the User’s Guide (page 17). Changing the sensor type You can select whether a window/door sensor functions as a window sensor or as a door sensor. For more information, refer to the User’s Guide (page 17). Wireless communication range The wireless communication range of each device in the system from the hub is approximately 50 m (160 feet) indoors and approximately 300 m (1, 000 feet) outdoors. Wireless communication may be unreliable when the following obstacles are located between the hub and other devices. R Metal doors or screens R Walls containing aluminum-sheet insulation R Walls made of concrete or corrugated iron R Double-pane glass windows R Multiple walls R When using each device on separate floors or in different buildings Note: R You can check the window/door sensor’s communication status by N. If the LED indicator pressing M is lit in green or red, the sensor is communicating properly with the hub. If the LED indicator blinks in red, it is out of range of the hub. Com/support Setup Temporary placement Before installing the window/door sensor, temporarily place it in the desired location and confirm that it operates properly by pressing M N. Important: R Attach the sensor unit to the outer frame of the window or door, and the magnet unit to the inner frame. R Attach both units so that the “ ” marks point toward each other and are within 25. R The window/door sensor will not operate properly if the “ ” marks are too far apart or are facing the wrong way. Confirming proper operation After temporarily placing the window/door sensor in the desired location, press N while the window or door is closed. The window/door sensor’s LED indicator M lights as follows. [. . . ] This Limited Warranty is extended only to the original purchaser and only covers products purchased as new. Mail-In Service--Online Online Repair Request To submit a new repair request and for quick repair status visit our Web Site at www. Com/repair When shipping the unit carefully pack in a padded shipping carton, include all accessories, and send it prepaid. Include a letter detailing the complaint, a return address and provide a day time phone number where you can be reached. [. . . ]