User manual PANASONIC KXHNS103

[. . . ] Com/prodreg In order to use this device: R Download the latest version of the [Home Network] app. R Update your hub to the latest firmware version (version 5. For more information, refer to the User’s Guide (page 18). 18 Features available when using the [Home Network] app . [. . . ] Indicator Green, lit Red, lit Red, blinking Green, blinking Off Status No water detected Water detected Sensor is out of range of the hub Registration mode (You pressed and held N) M No battery power E Note: R The LED indicator does not indicate sensor status if the sensor has not been registered (page 9). F G Main unit Main unit cover M N Used to confirm the status of the sensor or register the sensor to the hub. LED indicator Cable Probe unit Probes Setup overview 1 Initial setup Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub. insert the battery The sensor is battery powered. Registration Required only if the sensor was purchased separately (i. Confirm the usage area Read the information in this document to confirm that the desired installation area is suitable to proper operation. Installation Install the sensor in the desired location. 2 3 4 LED indicator N and check the You can press M LED indicator to confirm the sensor’s status. After confirming the sensor’s status, we recommend turning the LED indicator 5 8 For assistance, please visit www. Registering the sensor This procedure is not required for devices that were included as part of a bundle. R When installing on a wooden surface, use the included wall mounting adaptors. Secure the wall mounting adaptors to the wall using screws (not double-sided tape). R Mount the sensor on the stable location where the sensor can be adequately supported when mounting. R Do not mount the sensor on a soft material. It may fall down, break or cause injury. R Do not mount the sensor on the following places: gypsum board, ALC (autoclaved lightweight cellular concrete), concrete block, plywood less than 25. R The sensor may not be able to properly detect a water leak if the water contains contaminants such as oil, or if the water is frozen (i. Pdf 11 2015/02/03 20:01:37 Setup R Install the probe unit so that the metal probes are horizontal. A water leak can only be detected if water touches both of the metal probes; if water touches only one of the probes, a water leak will not be detected. Correct installation Metal probes are horizontal to the floor Incorrect installation Metal probes are not horizontal to the floor Installation location Install the water leak sensor in a basement, kitchen, utility room, or anywhere you want to detect a water leak. Common installation examples include near a washing machine, hot water heater, or a location where a water leak has occurred in the past. [. . . ] You must mail-in your product prepaid during the Limited Warranty period. This Limited Warranty excludes both parts and labor for batteries, antennas, and cosmetic parts (cabinet). This Limited Warranty only applies to products purchased and serviced in the United States or Puerto Rico. This Limited Warranty is extended only to the original purchaser and only covers products purchased as new. [. . . ]