User manual PANASONIC KXHNS104

[. . . ] This document explains how to install the glass break sensor properly. For details about how to use the system, refer to the User’s Guide (page 17). Please read this document before using the unit and save it for future reference. For assistance, please contact us at 1-800-272-7033 or visit our Web site: http://shop. [. . . ] Registering the sensor This procedure is not required for devices that were included as part of a bundle. For assistance, please visit http://shop. Pdf 9 2015/09/07 11:09:12 Setup Before you can use the sensor, it must be registered to the hub. , not as part of a bundle), you must register each device to the hub. You can register each device by using the registration buttons or the [Home Network] app. Note: R For information about deregistering devices, refer to the User’s Guide (page 17). Confirming the usage area Wireless communication range The wireless communication range of each device in the system from the hub is approximately 50 m (160 feet) indoors and approximately 300 m (1, 000 feet) outdoors. Wireless communication may be unreliable when the following obstacles are located between the hub and other devices. R Metal doors or screens R Walls containing aluminum-sheet insulation R Walls made of concrete or corrugated iron R Double-pane glass windows R Multiple walls R When using each device on separate floors or in different buildings Note: R You can check the sensor’s communication status by pressing M N. If the LED indicator is lit in green or red, the sensor is communicating properly with the hub. If the LED indicator blinks in red, it is out of range of the hub. Using registration buttons 1 Hub: 2 OTHER Press and hold M DEVICEN until the LED indicator blinks slowly in green. Sensor: Press and hold M N until the LED indicator blinks slowly in green (page 8). R When registration is complete, the hub sounds one long beep. Note: R To cancel without registering the N on the hub and sensor, press M on the sensor again. R If registration fails, the hub sounds several short beeps. Using the app When you register the sensor by using the [Home Network] app, you can assign a name to your devices and group them by location. For more information, refer to the User’s Guide (page 17). Usage area cautions Using the sensor in the following areas may cause deformation, malfunction, or operational failure. Pdf 10 2015/09/07 11:09:12 Setup R Near fire or heating devices R Near magnetic fields (such as near microwaves and magnets) R Areas subject to extreme temperature changes, such as next to air conditioners R Near devices that emit strong radio waves, such as mobile phones For assistance, please visit http://shop. Walls or other obstacles between the window and the sensor may prevent the sensor from detecting breaking glass, even when the sensor is installed within the ranges listed here. When looking from above When looking from the side A B D D C E Sensor Vertical range: approx. [. . . ] ) Panasonic Products Limited Warranty Limited Warranty Coverage (For USA Only) If your product does not work properly because of a defect in materials or workmanship, Panasonic Corporation of North America (referred to as “the warrantor”) will, for the length of the period indicated on the chart below, which starts with the date of original purchase (“warranty period”), at its option either (a) repair your product with new or refurbished parts, (b) replace it with a new or a refurbished equivalent value product, or (c) refund your purchase price. The decision to repair, replace or refund will be made by the warrantor. Product or Part Name Home Network System Products microSD card (Included model only) Parts One (1) Year 90 days Labor One (1) Year N/A During the “Labor” warranty period there will be no charge for labor. During the “Parts” warranty period, there will be no charge for parts. [. . . ]