User manual PANASONIC KXHNS105E

[. . . ] Installation Guide Home Network System Indoor Siren Model No. KX-HNS105E Thank you for purchasing a Panasonic product. This document explains how to install the indoor siren properly. For details about how to use the system, refer to the User’s Guide (page 13). Please read this document before using the unit and save it for future reference. [. . . ] R The product should be kept free from excessive smoke, dust, high temperature, and vibration. R The product should not be exposed to direct sunlight. R Do not place heavy objects on top of the product. R When you leave the product unused for a long period of time, unplug the product from the power outlet. R The product should be kept away from heat sources such as radiators, cookers, etc. It should not be placed in rooms where the temperature is less than 0 °C or greater than 40 °C. R Operating the product near electrical appliances may cause interference. This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points in accordance with your national legislation. By disposing of them correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment. For more information about collection and recycling, please contact your local municipality. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. Move away from the electrical appliances. Other information Routine care R Wipe the outer surface of the product with a soft moist cloth. R Do not use benzine, thinner, or any abrasive powder. Disposal of Old Equipment (Only for European Union and countries with recycling systems) Helpline Tel. 0330 3331112 Ireland 01 4475228 7 HNS105E_(en_en)_0428_ver. 062. pdf 7 2015/04/28 11:36:21 Setup Part names and functions LED indicator You can use the LED indicator to confirm the siren’s status. Indicator Green, lit Red, blinking slowly Red, blinking Red, blinking quickly Green, blinking Status Normal operation Siren is not registered to a hub Siren is out of range of the hub Alarm system was triggered Registration mode (You pressed and held M N) No power A B C D E Off F Setup overview 1 Initial setup Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub. Registration Required only if the siren was purchased separately (i. e. , not as part of a bundle). Confirm the installation area Read the information in this document to confirm that the desired installation area is suitable to proper operation. Horn Strobe light Flashes when the siren is sounding. LED indicator MHIGHN/MLOWN Used to adjust the siren’s volume (page 13). Rear cover M N Used to register the siren to the hub. 2 3 8 Helpline Tel. [. . . ] 0330 3331112 Ireland 01 4475228 13 HNS105E_(en_en)_0428_ver. 062. pdf 13 2015/04/28 11:36:21 Appendix Specifications R Standards DECT (Digital Enhanced Cordless Telecommunications) R Frequency range DECT: 1. 88 GHz – 1. 90 GHz R RF transmission power DECT: Approx. 10 mW (average power per channel) R Power source 220 – 240 V AC, 50/60 Hz R Power consumption Standby: Approx. 3. 0 W R Alert tone volume High alert level: approx. 10 cm from the product) R Operating conditions 0 °C – 40 °C R Dimensions (height ´ width ´ depth) Approx. [. . . ]