User manual PANASONIC KX-MB2061E IMPORTANT INFORMATION

[. . . ] Important Information Guide Multi-Function Printer Model No. KX-MB2061E Do NOT connect the unit to a computer with the USB cable until prompted to do so during the setup of Multi-Function Station (CD-ROM). 1 2 Accessory information: To ensure that the unit operates properly, we recommend the use of Panasonic toner and drum cartridges. n Replacement accessory – Toner cartridge R Model No. (Part No. ): KX-FAT411X – Drum cartridge R Model No. [. . . ] If the unit exhibits a distinct change in performance. USB cable/LAN cable R To assure continued emission limit compliance; – use only shielded USB cable (Example: Hi-Speed USB 2. 0 certified cable). – use only shielded LAN cable (category 5 straight cable). Cordless handset communication R Unplug from power outlets and never touch the inside of the product if its casing has been broken open. R Do not place or use this product near automatically controlled devices such as automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction resulting in an accident. R Do not allow the AC adaptor or telephone line cord to be excessively pulled, bent or placed under heavy objects. R Consult the manufacturer of any personal medical devices, such as pacemakers or hearing aids, to determine if they are adequately shielded from external RF (radio frequency) energy. (The product operates in the frequency range of 1. 88 GHz to 1. 90 GHz, and the RF transmission power is 250 mW (max. ). ) R Do not use the product in health care facilities if any regulations posted in the area instruct you not to do so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF energy. 1. 1. 2 CAUTION Installation and relocation R After moving the unit from cold areas to warmer areas, wait approximately 30 minutes before turning on the power switch to allow the unit to adjust to the ambient temperature. If the power switch is turned on too soon after a sudden climate change, condensation may form inside the unit, causing malfunction. R Never turn the unit upside down or sideways when moving it. R Never install telephone wiring during a lightning storm. R Never install telephone sockets in wet locations unless the socket is specifically designed for wet locations. R Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. R Use caution when installing or modifying telephone lines. R Do not position the unit in a location where it is unstable or subject to vibrations. Operating safeguards R When opening/closing the top cover, hold the indentations on both sides of the unit (A). Detailed operating instructions are on the CD-ROM. 3 1. Important Information – To prevent injuries, be careful not to put your hands under the top cover. R Exercise care when handling the battery(ies). Do not allow conductive materials such as rings, bracelets or keys to touch the battery(ies), otherwise a short circuit may cause the battery(ies) and/or the conductive material to overheat and cause burns. R Charge the battery(ies) provided with or identified for use with this product only in accordance with the instructions and limitations specified in the operating instructions. R Only use a compatible charger to charge the battery(ies). [. . . ] Important Information For your safety This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced please ensure that the replacement fuse is of the same rating and that it is approved by ASTA or BSI to BS1362. Check for ASTA mark mark or the BSI IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Green-and-Yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured GREEN-ANDYELLOW must be connected to the terminal in the plug which is marked with the letter E or by the Earth symbol or coloured GREEN or GREEN-AND-YELLOW. [. . . ]