User manual PANASONIC KX-NT321

[. . . ] Quick Reference Guide IP Proprietary Telephone Model No. KX-NT321 Thank you for purchasing an IP Proprietary Telephone (IP-PT). Please read this manual carefully before using this product and save this manual for future use. For more details, please refer to the manuals of the PBX. [. . . ] Drive the 2 screws into the wall either 83 mm (3-1/4 in) or 100 mm (3-15/16 in) apart, and mount the unit on the wall. · You can find a wall mounting 83 mm template on page 19. (3-1/4 in) · Make sure that the wall that the 100 mm (3-15/16 in) unit will be attached to is strong enough to support the unit (approx. · Make sure the cables are securely Washer fastened to the wall. Drive the screw · When this unit is no longer in use, to this point. make sure to detach it from the wall. Locking the Handset Hook Pull down the handset hook until it locks to prevent the handset from falling off the handset cradle when the unit is mounted to a wall or set at a high angle. To temporarily place the handset down during a conversation, hook it over the top edge of the unit as shown. Document Version 2008-05 13 Important Information Important Information When using a KX-NT321 IP-PT, keep the following conditions in mind. · If the unit does not operate properly, disconnect the unit from the Ethernet cable and then connect again. · If you are having problems making calls, disconnect the Ethernet cable and connect a known working IP-PT. If the known working IP-PT operates properly, have the defective IP-PT repaired by an authorized Panasonic factory service center. If the known working IP-PT does not operate properly, check the PBX and the Ethernet cable. · Wipe the unit with a soft cloth. Do not clean the unit with abrasive powders or with chemical agents such as benzene or thinner. · Use only the correct Panasonic handset. Dangerous electrical shock could result. The unit must only be disassembled and repaired by qualified service technicians. · If damage to the unit exposes any internal parts, immediately disconnect the cable or cord. If the power is supplied from the network to the IP-PT [Power-over-Ethernet], disconnect the Ethernet cable. Otherwise, disconnect the AC adaptor cord. Then return this unit to a service center. · Never attempt to insert wires, pins, etc. into the vents or other holes of this unit. Take special care to follow the safety suggestions listed below. Safety 1) The unit should only be connected to a power supply of the type described in the Quick Reference Guide or as shown on the label on the unit. 2) When left unused for a long period of time, the optional AC adaptor should be unplugged from the AC outlet, if you are using Power-overEthernet, disconnect the Ethernet cable. Installation Environment 1) Do not use this unit near water, for example, near a bathtub, washbowl or sink. [. . . ] 13. Avoid using a telephone (other than a cordless type) during an electrical storm. There is a remote risk of electric shock from lightning. 14. Do not use the telephone in the vicinity of a gas leak to report the leak. SAVE THESE INSTRUCTIONS 16 Document Version 2008-05 Important Information FCC Information F. C. C. REQUIREMENTS AND RELEVANT INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]