User manual PANASONIC KX-P7105

[. . . ] Note: · Paper, Transparencies or Envelopes can be loaded in the media tray. · When loading legal paper, see "Loading Media and Printing" of "Settings and Printing" in the Operating Instructions. # # % Paper Full Paper Low or Empty Step 2 Connecting Cables A When using the parallel interface cable: Note: · Use a shielded cable 2. 0 m (6. 6 ft) or less in length. Note: If you do not have a parallel interface cable or USB cable, you will need to purchase one. A Parallel interface # B When using the USB interface cable: $ Note: · Use a shielded cable 5. 0 m (16. 4 ft) or less in length. [. . . ] BAll other acknowledgements are trademarks or registered trademarks of their respective holders. LaserActTM 6 Copyright © 2001, Destiny Technology Corp. PageStylerTM II Copyright © 2001, Destiny Technology Corp. Acrobat® Reader copyright © 1987-1999 Adobe Systems Incorporated. The instructions are subject to change without notice. © Kyushu Matsushita Electric Co. , Ltd. 2001 From Programs Menu Programs H -- Panasonic H -- Panasonic KX-P7105 and KX-P7110H -- Connect our Web Site Network Setup Guide Operating Instructions Remote Control Panel Setup for Status Display Setup Guide Status Display Uninstall driver and utility On Task Bar : The Status Display will remain in the task bar and pop-up if an error occurs. s System Requirement To operate the printer effectively, see the following: CPU Operating System: Memory Drive: Pentium 133 MHz or greater Windows 95*2, Windows 98, Windows Me, Windows NT® 4. 0*3 or Windows 2000 / Mac OS 8. 5, Mac OS 8. 6, Mac OS 9, Mac OS 9. 1 or Mac OS9. 2*4 16 MB or more (More than 32 MB is recommended. ) CD-ROM drive The serial number is located on the label on the rear of the printer. For your convenience, record the number below and keep this guide along with your proof of purchase, in the event of a theft or for future reference. NAME OF RESELLER DATE OF PURCHASE *2 Microsoft® Windows® 95 operating system (hereafter Windows 95) *3 Microsoft® Windows NT® operating system Version 4. 0 (hereafter Windows NT 4. 0) *4 Optional Upgrade Kit (for PostScript) must be installed in the printer. For Your Safety General Warning To prevent fire or shock hazard, do not expose this product to rain or any type of moisture. Laser Safety Caution This printer utilizes a laser. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous laser radiation exposure. Laser diode properties Laser output: 5 mW max Wavelength: 785 nm Emission duration: Continuous Caution Do not open covers and do not attempt to repair the unit yourself. Refer servicing to qualified personnel. Power Source Warning · The power source voltage of this unit is listed on the nameplate (located on the rear of the printer). Only plug the unit into an outlet with the proper voltage. The voltage level of the power source must not vary more than ±10% from the proper voltage level. · When you operate this equipment, the outlet should be near the equipment and accessible. · To ensure safe operation the AC cord supplied must be inserted into standard three-prong AC outlet which is effectively grounded (earthed) through the normal wiring. · The fact that the equipment operates satisfactorily does not imply that the power point is grounded (earthed) and that the installation is completely safe. For your safety, if in any doubt about the effective grounding (earthing) of the power point, consult a qualified electrician. · If the plug cannot be inserted into the AC outlet, contact a licensed electrician to replace the outlet with a properly grounded (earthed) one. · Do not defeat the purpose of the grounding (earthing) plug (ex. · Do not use an extension cord. Ozone Release Warning Make sure that the printer is installed in a well ventilated room so as not to increase density of ozone in the air. Since ozone is heavier than air, it is recommended that air at floor level be ventilated. Caution Labels CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT CLASSE 1 LASER PRODUIT CLASE 1 LÁSER PRODUCTO (220-240 V equipment) CAUTION HOT SURFACE INSIDE (220 - 240 V equipment) A certified power supply cord has to be used with this equipment. [. . . ] This will void the warranty of the printer and supplies. READY ERROR TONER/ DRUM UNIT *1 READY ERROR Toner is low. Drum unit is wearing out. Replace the toner cartridge soon. Replace the drum unit soon. Panasonic Digital Imaging Solutions Company Business Unit of Matsushita Electric Corporation of America Two Panasonic Way, Secaucus, New Jersey 07094 To locate your nearest sales dealer CALL 1-800-742-8086 To order consumables CALL 1-800-833-9626 For technical support CALL 1-800-726-2797 Panasonic Sales Company (PSC) Division of Matsushita Electric of Puerto Rico, Inc. 9. 5, San Gabriel Industrial Park Carolina, Puerto Rico 00985 Panasonic Canada Inc. [. . . ]