User manual PANASONIC KXPRD250EX1

[. . . ] KX-PRL250EX1 KX-PRD250EX1 Quick Guide Connections Important: L To use link to mobile feature only, a telephone line cord is not required. L If you want to use a landline feature but the supplied telephone line cord is not available for your country, please contact your nearest Panasonic service centre for sales information. in this case , set “Mobile Line Only Mode” to “Off” (page 6). Base unit 1 Run the telephone line cord ( 1 ) and AC adaptor ( 2 ) through the slot of the stand. [. . . ] L A disconnected mobile phone is not unpaired from the base unit, so pairing it to the base unit again is unnecessary. Base unit: To connect Press { } and wait for a few seconds for the mobile phone and base unit to connect to each other. ) 2 {m} Mobile line only mode (If you do not use the landline) (Handset) If you do not use the landline, set the mobile line only mode to use this unit more conveniently. the default setting is “On”. L If you turn on the “Mobile Line Only Mode”, disconnect the telephone line cord from the base unit. Otherwise the “Mobile Line Only Mode” cannot be activated. 1 {6} (right soft key) (157 2 To turn on: {r}: “On” s {OK} s {r}: “Yes” s {OK} To turn off: {r}: “Off” s {OK} 6 PRL250EX1_PRD250EX1(4lang)_QG. Book Page 7 Monday, October 20, 2014 7:47 PM Basic operations Making/Answering calls (Handset) Making mobile calls 1 2 Making landline calls Answering calls To hang up To adjust the receiver/ speaker volume Making a call using the redial list Dial the phone number. S {5} L When the mobile line only mode is set, you can also press {C}/{s} instead of {5}. L When only 1 mobile phone is paired, the unit starts dialling. When 2 mobile phones are paired: {r}: Select the desired mobile phone. To make a mobile call: When only 1 mobile phone is paired: {5} or When 2 mobile phones are paired: {5} s {r}: Select the desired mobile phone. S {OK} To make a landline call: {C}/{s} Temporary tone dialling (for rotary/pulse service users) Important: L If you select “United Kingdom” or “Deutschland” as the unit’s region setting (page 3), the temporary tone dialling is not available because it is not required for these countries. Press * before entering access numbers which require tone dialling. Press {^} or {V} repeatedly to select the desired volume while ringing. to adjust the ringer volume (mobile line/landline) 7 PRL250EX1_PRD250EX1(4lang)_QG. Book Page 8 Monday, October 20, 2014 7:47 PM Basic operations Phonebook (Handset) Adding entries 1 2 3 4 {k} s {6} {r}: “New Entry” s {OK} {r}: “(Name)” s {OK} Enter the party’s name (16 characters max. S {OK} L You can change the character entry mode by pressing {R/ECO}. L To enter a name, see the character table in the operating instructions. 5 {r}: Select the desired phone number location. S {OK} 6 Enter the party’s phone number (24 digits max. S {OK} L To store 2 or 3 phone numbers, repeat steps 5-7. [. . . ] Cause/solution L The handset is too far from the base unit. L The handset is not registered to the base unit. L Depending on the compatibility of the mobile phone, you may not be able to pair it to the base unit. L Confirm that the Bluetooth feature of your mobile phone is turned on. [. . . ]