User manual PANASONIC KX-R190

[. . . ] · Attach a letter, detailing the symptom, to the outside of the carton. Symptom · Send the unit to an authorized servicenter, prepaid and adequately insured. · Do not send your unit to the Panasonic Consumer Electronics Company listed below or to executive or regional sales offices. These locations do not repair consumer products. Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way, Secaucus, New Jersey 07094 Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. [. . . ] ·The first call is put on hold and you can answer the second call. ·To return to the first caller, press (FLASH) again. ·If this function does not operate properly, consult your telephone company for details. 5-B Automatic Security Code Setting Whenever you place the handset on the base unit, the unit automatically selects one of more than a million security codes. These codes help prevent the unauthorized use of your telephone line by another cordless telephone user. ·Pressing (PAUSE) once creates a 3. 5 second pause. This prevents misdialing when you redial or dial a stored number. ·Pressing (PAUSE) more than once increases the length of the pause between numbers. 5-E Handset Locator 5-C Temporary Tone Dialing (For Rotary or Pulse Service Users) Press (TONE) before entering access numbers which require tone dialing. ·The dialing mode changes to tone. You can enter numbers to access an answering service, electronic banking service, etc. When you hang up, the mode will return to pulse. ·Access numbers entered after pressing (TONE) will not be included when redialing. You can locate the handset or page the handset user with beep tones. unit. Otherwise, the battery may not charge properly. ·If the battery is fully charged, you do not have to place the handset on the base unit until the RECHARGE indicator flashes. ·The battery cannot be overcharged. 6-B Belt Clip You can hang the handset on your belt or pocket using the belt clip. 6-E Battery Replacement If the RECHARGE indicator flashes after being fully charged, replace the battery with a new Panasonic P-P510 (N4HKGMB00001) battery. To order, call the accessories telephone number in section 1-A. To attach the belt clip To remove the belt clip 1 6-C Optional Headset Plugging an optional headset into the handset allows a hands-free phone conversation. Please use only the Panasonic KX-TCA88 headset. To order, call the accessories telephone number in section 1-A. Carefully insert a flat metal object in the slot, and push forward to release the lock. Place the battery leads inside the groove, otherwise the leads may be damaged when closing the cover. Make sure to charge the new battery for 6 hours. 1 Push forward. 2 3 Headset Jack Connecting the optional headset to the handset Open the headset jack cover, and connect the optional headset to the headset jack as shown. H 2 When the optional headset is connected to the handset, make sure to use the headset to talk with the caller. If you want to have a normal cordless phone conversation, disconnect the headset. Attention: The product you have purchased is powered by a nickel cadmium battery which is recyclable. At the end of its useful life, under various state and local laws, it is illegal to dispose of this battery into your municipal waste stream. Please call 1-800-8-BATTERY for information on how to recycle this battery. Things You Should Know 6-F Before Requesting Help Problem The unit does not work. [. . . ] If the known working phone does not operate properly, consult your telephone company. Caution: To comply with FCC RF exposure requirements, the base unit should be installed with its antenna located at 20 cm or more from persons and handset should be carried with the specific belt-clip provided for the handset to ensure compliance. Other non-tested belt-clips or similar bodyworn accessories may not comply, therefore, should be avoided. Static, sound cuts in/out, fades. Interference from other electrical units. The unit does not ring. While storing a phone number, the unit starts to ring. [. . . ]