User manual PANASONIC KX-RC22

[. . . ] 31 Voice Mail Service Voice mail service. 33 Important Information For your safety . 34 Transferring calls, conference calls . 36 36 37 39 40 46 Getting Started Setting up . [. . . ] *9 The recall/flash time depends on your telephone exchange or host PBX. Contact your PBX supplier if necessary. Helpline Tel. 01289 8333 21 TG6481E(e). book Page 22 Thursday, May 7, 2009 1:36 PM Programming Special programming Alarm You can set one of 2 different alarm options (once or daily) at a time for each handset. An alarm sounds at the set time for 3 minutes. Important: L Set the date and time beforehand (page 15). L To stop the alarm, press any dial key or place the handset on the base unit or charger. L When the handset is in use, the alarm will not sound until the handset is in standby mode. L If you select "Once", the setting changes to "Off" after the alarm sounds. 1 2 3 4 5 K (middle soft key) {V}/{^}: "Handset Setup" i M {V}/{^}: "Time Settings" i M {V}/{^}: "Alarm" i M {V}/{^}: Select the desired alarm option. "Once" An alarm sounds once at the set time. "Daily" An alarm sounds daily at the set time. Changing the base unit PIN (Personal Identification Number) Important: L If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, see page 41. 1 2 3 4 5 K (middle soft key) {V}/{^}: "Base Unit Setup" i M {V}/{^}: "Base Unit PIN" i M Enter the current 4-digit base unit PIN (default: "0000"). i M L If you forget your PIN, see page 41. L When the handset has been registered successfully, w stops flashing. L To cancel a selected handset number, press the number again. The number stops flashing. 6 5 {V}/{^}: "Yes" i M L A confirmation tone sounds as each handset number disappears. L The handset does not beep when cancelling its own registration. {ic} 7 Increasing the range of the base unit You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Contact your Panasonic dealer for details. Important: L Before registering the repeater to this base unit, you must turn the repeater mode on. L Do not use more than one repeater at a time. Setting the repeater mode Note: L When you purchase an additional handset, refer to the additional handset's installation manual for registration. Deregistering a handset A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. [. . . ] Answer the call and try again later. My own greeting message cannot be properly heard. I cannot operate the answering system. I cannot operate the answering system remotely. While recording a greeting message or listening to messages, the unit rings and the operation stops. 44 Helpline Tel. 01289 8333 TG6481E(e). book Page 45 Thursday, May 7, 2009 1:36 PM Useful Information Liquid damage Problem Liquid or other form of moisture has entered the handset/base unit. Cause/solution L Disconnect the AC adaptor and telephone line cord from the base unit. [. . . ]