User manual PANASONIC KX-T3185

[. . . ] · Attach a letter, detailing the symptom, to the outside of the carton. Symptom · Send the unit to an authorized servicenter, prepaid and adequately insured. · Do not send your unit to the Panasonic Consumer Electronics Company listed below or to executive or regional sales offices. These locations do not repair consumer products. Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way, Secaucus, New Jersey 07094 Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. [. . . ] ·If this function does not operate properly, consult your telephone company for details. 5-B Automatic Security Code Setting Whenever you place the handset on the base unit, the unit automatically selects one of more than a million security codes. These codes help prevent the unauthorized use of your telephone line by another cordless telephone user. ·Pressing (PAUSE) once creates a 3. 5 second pause. This prevents misdialing when you redial or dial a stored number. ·Pressing (PAUSE) more than once increases the length of the pause between numbers. 5-E Handset Locator 5-C Temporary Tone Dialing (For Rotary or Pulse Service Users) Press (TONE) before entering access numbers which require tone dialing. ·The dialing mode changes to tone. You can enter numbers to access an answering service, electronic banking service, etc. When you hang up, the mode will return to pulse. ·Access numbers entered after pressing (TONE) will not be included when redialing. You can locate the handset or page the handset user with beep tones. unit. 1 PressIN(HANDSETÒLOCATOR) on the base the handset beeps for 1 ·The USE/CHARGE indicator flashes and minute. 2 To stop paging, press (HANDSETÒLOCATOR) again or press (TALK) twice on the handset. 4 (DIRECT) One-Touch Dialer Section 4 4-A Storing a Phone Number in the DIRECT Button You can store a phone number in the (DIRECT) button. The stored number is dialed with a one-touch operation. In a HIGH and CENTRAL location with no obstructions such as walls. 6-B Battery Replacement If the RECHARGE indicator flashes after being fully charged, replace the battery with a new Panasonic P-P510 (N4HKGMB00001) battery. To order, call the accessories telephone number in section 1-A. Raise the antennas. 1 2 3 Carefully insert a flat metal object in the slot, and push forward to release the lock. Place the battery leads inside the groove, otherwise the leads may be damaged when closing the cover. Make sure to charge the new battery for 6 hours. 1 Push forward. Note: While using the handset: -- If you are near a microwave oven which is being used, noise may be heard at the receiver. Move away from the microwave oven and closer to the base unit. -- If more than one cordless phone is being used and your handset is near another cordless phone's base unit, noise may be heard. Move away from the other cordless phone's base unit and closer to your base unit. 6-E Adding Another Phone 2 This unit will not function during a power failure. To connect a standard telephone on the same line, use the Panasonic T-adaptor KX-J66. To order, call the accessories telephone number in section 1-A. Standard Telephone Attention: The product you have purchased is powered by a nickel cadmium battery which is recyclable. At the end of its useful life, under various state and local laws, it is illegal to dispose of this battery into your municipal waste stream. [. . . ] · Keep the handset away from salt water. · Avoid exposure to prolonged high humidity. · Since water in headset jack may cause damage, close the headset jack cover when the optional headset is not in use. When the optional headset is connected, do not use the handset with wet hands. [. . . ]