User manual PANASONIC KX-T3816BE

[. . . ] 16 Programming Summary of Preparations . 19 Preparation Basic Operation Making Calls . 11 Basic Operation Advanced Operation Speed Dialer . 17 Temporary Tone Dialing (For Rotary or Pulse Service Users) . [. . . ] 17). 12 To erase a stored number 1 2 3 Press (PROGRAM). The MUTE indicator flashes. Press (AUTO/LOWER). Press a memory station number ((0) to (9)) for the phone number to be erased. A long beep sounds. The unit will return to the standby mode. Dialing a Stored Number 1 2 3 Lift the handset or press (SP-PHONE/HEADSET). Press the memory station number ((0) to (9)). The stored number is dialed. 13 Advanced Operation One-Touch Dialer Storing Phone Numbers in Memory You can store up to 20 phone numbers in the one-touch auto dial buttons (10 numbers in UPPER memory locations, 10 numbers in LOWER memory locations). Do not press any one-touch auto dial buttons before storing to prevent misoperation. Make sure that a call is not put on hold. To store in an UPPER memory location It is recommended that you program an emergency number in the EMERGENCY button. 1 2 3 Press (PROGRAM). The MUTE indicator flashes. One-touch auto dial buttons (EMERGENCY) (PROGRAM) Enter a phone number, up to 22 digits. If you enter a wrong number, press (PROGRAM) and start again from step 1. Press one of the onetouch auto dial buttons. A long beep sounds. (AUTO/LOWER) The MUTE indicator light (PAUSE) goes out. The unit will return to the (SP-PHONE/HEADSET) and Indicator standby mode. If 3 beeps sound, the number entered in step 2 may be over 22 digits. Press (PROGRAM) to return to the standby mode and start again from step 1. If a pause is required for dialing, press (PAUSE) where needed. Pressing (PAUSE) counts as one digit (p. 22), you cannot store a phone number in the EMERGENCY button. 14 " To store in a LOWER memory location 1 2 3 4 Press (PROGRAM). The MUTE indicator flashes. Enter a phone number, up to 22 digits. If you enter a wrong number, press (PROGRAM) and start again from step 1. Press (AUTO/LOWER). Press one of the one-touch auto dial buttons. A long beep sounds. Only incoming calls are accepted until the dial lock is canceled. Before using this feature, we recommend storing an emergency number in the memory (EMERGENCY) of the EMERGENCY button (p. Even if the dialing buttons are locked, the number stored in the button can be dialed. If you choose not to program emergency numbers, but plan to use the dial lock, any number programmed into the EMERGENCY button can be accessed. M IC To set the dial lock 1 2 3 Press (DIAL\LOCK). The MUTE indicator flashes. Enter the PIN code (p. 20). Advanced Operation Press (PROGRAM). A long beep sounds. If a wrong PIN code is entered, 3 beeps will sound. Enter a correct PIN code and press (PROGRAM). The unit will return to the standby mode. You can use the following features while the dialing buttons are locked. Dialing a number you programmed into the memory of the EMERGENCY button (p. 16) Adjusting the handset and speakerphone volumes (p. 18) Answering the second call by pressing (FLASH) (p. 17) To cancel the dial lock Follow steps 1 through 3 above again. 21 " Special Features Call Restriction You can prevent the unit from dialing phone numbers beginning with specified digit(s) (1 digit or 2 digits). [. . . ] Do not subject this unit to excessive smoke, dust, mechanical vibration or shock. CAUTION: To reduce the risk of fire or injury to persons, read and follow these instructions. Do not dispose of the battery(ies) in a fire. Do not open or mutilate the battery(ies). [. . . ]