User manual PANASONIC KX-TC1400W

[. . . ] For assistance, visit our website: http://www. panasonic. com/phonehelp for customers in the U. S. A. or Puerto Rico. Table of Contents Introduction Introduction. 8 Symbols used in these operating instructions . 12 Camera Monitoring Camera monitoring using a handset . [. . . ] (program) on the back side of the cordless camera with a pointed object such as a pen until a beep sounds. L When registration is completed successfully, the cordless camera beeps and the indicator stops flashing red but remains lit in yellowgreen (page 7). 1 2 2 Press and hold {INTERCOM} until the IN USE indicator flashes. Press and hold the cordless camera's extension number ({1} ­ {8}) until a beep sounds. Note: L The indicator color on the camera remains the same. 12 For assistance, please visit http://www. panasonic. com/phonehelp Camera Monitoring Camera monitoring using a handset L The cordless camera may not page handsets in the following conditions: ­ when other users are on an intercom or conference call. ­ when electrical interference is emitted from electrical devices. ­ while you are on a call with the handset. (In this case you will hear 2 tones and z will flash on the handset. ) Monitoring the cordless camera from a handset With a color display handset (KXTGA571), you can monitor the image and sound of the room where the cordless camera is located. The monitored camera does not ring, allowing you to easily monitor a baby's room, for example, from different areas of the house. Important: L Before you start monitoring, confirm that the camera lens of the cordless camera has been adjusted to the correct angle. L Only 1 person can access the cordless camera at a time. L A refreshed image taken by the cordless camera is displayed every few seconds. The displayed image is not a moving picture. Push {^} or {V} to select the desired sensitivity. L To turn this feature off, push {V} repeatedly. {SAVE} 5 Note: L When you turn this feature off, the cordless camera cannot detect sound (page 14). L To set the appropriate level, test the sensor of the camera from the handset beforehand. 16 For assistance, please visit http://www. panasonic. com/phonehelp Useful Information Wall mounting The cordless camera can be mounted by the standard mounting or upside down mounting. CAUTION: L Mount the cordless camera on the stable location where the unit can be adequately supported when installing. L The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected. L Do not mount the cordless camera on a soft material. It may fall down, break or cause injury. L Do not mount the cordless camera on the following places: plaster board, ALC (autoclaved lightweight cellular concrete), concrete block, plywood less than 25 mm (1 inch) thick, and etc. L Do not pull the call button wire after you mount the cordless camera on the wall. [. . . ] During the "Parts" Limited Warranty period, there will be no charge for parts. You must mail-in your product prepaid during the Limited Warranty period. This Limited Warranty excludes both parts and labor for batteries, antennas, and cosmetic parts (cabinet). This Limited Warranty only applies to products purchased and serviced in the United States or Puerto Rico. [. . . ]