User manual PANASONIC KX-TC1701G

[. . . ] Read and understand all instructions. Caller ID and Call Waiting Service, where available, are telephone company services. After subscribing to Caller ID, this phone will display a caller's name and phone number. Call Waiting Caller ID, which displays a second caller's name and phone number while the user is on another call, requires a subscription to both Caller ID and Call Waiting with Caller ID services (CWID). Attach your purchase receipt here. For your future reference Serial No. (found on the bottom of the unit) Date of purchase Name and address of dealer Accessories (included) For extra orders, call 1-800-332-5368. [. . . ] Mount the unit, then slide down. Raise the antenna. Wall Phone Plate 28 5 To charge the battery: Fit the handset hole in the tab (1) and fix the charge contacts (2). Make sure to place the handset with the keypad facing down. 1 Hole Tab 2 Adding Another Phone This unit will not work during a power failure. To connect a standard telephone on the same line, use the Panasonic KX-J66 T-adaptor. To order, call the accessories telephone number on page 2. Standard Telephone Useful Information Telephone Line Cord Single-Line Telephone Jack T-Adaptor (KX-J66) For assistance, please call: 1-800-211-PANA(7262) 29 Battery Replacement If "RECHARGE" and " " are displayed after a few telephone calls even if the battery was fully charged, replace the battery with a new Panasonic PQWBTC1461M (P-P504) battery. To order, call the accessories telephone number on page 2. 1 Press the notch on the handset cover firmly (1) and slide it as indicated by the arrow (2). 1 2 2 Remove the old battery. Then install the new one. Insert the battery plug into the connector as shown in the picture. Be sure wires are free from being pressed by the battery body or handset cover. Black Lead Red Lead 3 Close the cover. Make sure you charge the new battery for 15 hours. A nickel cadmium battery that is recyclable powers the product you have purchased. At the end of its useful life, under various state and local laws, it is illegal to dispose of this battery into your municipal waste stream. Please call 1-800-8-BATTERY for information on how to recycle this battery. 30 Troubleshooting Problem The unit does not work. " Cause and Remedy Check the settings (p. Do not pause for over 60 seconds while searching. The display goes to the standby mode while viewing the Caller List. When a second call is The caller requested not to send his/her received during a information. conversation, the unit does not display the new caller's name and/or phone number. The handset is too far from the base unit. The handset is engaged in an outside call. Wait until the IN USE/CHARGE indicator light goes out. 32 Problem You cannot redial by pressing [PAUSE/REDIAL]. Cause and Remedy When pressing [PAUSE/REDIAL] after [ /FLASH] , more than 32 digits long number will not be redialed correctly. When pressing after [ /FLASH] [PAUSE/REDIAL], more than 24 digits long number will not be redialed correctly. The button functions as either redial or pause. It will redial the last number dialed if pressed at the outset of a call (p. If another number has been dialed first, it will operate as a pause button (p. 8). "RECHARGE" and " " are displayed or the handset beeps intermittently. While talking, the call is disconnected. [. . . ] The decision to repair or replace will be made by the warrantor. Parts Labor One (1) Year One (1) Year During the "Labor" Limited Warranty period there will be no charge for labor. During the "Parts" Limited Warranty period, there will be no charge for parts. You must mail-in your product during the Limited Warranty period. [. . . ]