User manual PANASONIC KX-TC1703G

[. . . ] These locations do not repair consumer products. If you need assistance with the setup or operation, please call 1-800-211-PANA(7262) For hearing or speech impaired TTY users, TTY : 1-877-833-8855 Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way, Secaucus, New Jersey 07094 Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. 9. 5, San Gabriel Industrial Park Carolina, Puerto Rico 00985 © 2004 Panasonic Communications Co. , Ltd. All Rights Reserved. PQQX13980YA S1203-1014 1 Getting Started 1-B Location of Controls Handset Back side Antenna Speaker CHARGE Indicator (1-C) Charge Contacts (4-A) Receiver RECHARGE Indicator (4-A) [OFF] Button (2-A) [REDIAL] Button (2-A) VOL. (VOLUME) Key ([M], [L]) (2-A, 2-B) [VOICE ENHANCER] Button and Indicator (1-C, 2-A) Section 1 1-A Accessories AC Adaptor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . one Order No. [. . . ] · The TALK indicator on the handset and the IN USE indicator on the base unit flash rapidly, and the handset beeps for 1 minute. To stop paging, press [HANDSET LOCATOR] again or press [OFF] on the handset. · You can also stop paging on the handset by pressing any button except [M] or [L]. 4-A Battery Recharge When the RECHARGE indicator flashes or Indicator the handset beeps intermittently, place the handset on the base unit for 6 hours to recharge the battery. · The RECHARGE indicator will flash when the handset battery is charged less than 15 minutes and the handset is lifted off the base unit. Battery replacement: If you cleaned the charge contacts and fully charged the battery, but after a few telephone calls, the RECHARGE indicator flashes, the battery may need to be replaced. Please order a new Panasonic HHR-P104 battery at the telephone number shown on section 1-A. To replace the battery, see section 1-C, step 2. A nickel metal hydride battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY for information on how to recycle this battery. 3-B Temporary Tone Dialing (For Rotary or Pulse Service Users) Press [ ] (TONE) before entering access numbers which require tone dialing. · The dialing mode changes to tone. You can enter numbers to access an answering service, electronic banking service, etc. When you hang up, the dialing mode will return to pulse. 3-C For Call Waiting Service Users Press [FLASH/CALL WAIT] if you hear a call waiting tone during a conversation. Otherwise the battery may not charge properly. 4-B Belt Clip You can hang the handset on your belt or pocket using the included belt clip. To attach the belt clip To remove the belt clip For assistance, please call: 1-800-211-PANA(7262) Things You Should Know 4-C Shoulder Rest Attachment Use the shoulder rest attachment if you need to keep your hands free during a phone conversation. To attach the shoulder rest attachment Attach the included belt clip to the handset (4-B), then attach the shoulder rest attachment to the belt clip as shown below. You will hear a click when the shoulder rest attachment is in place. To remove the shoulder rest attachment Slide the base of the attachment in the direction of the arrow as shown below. 4-D Optional Headset Connecting an optional headset to the handset allows hands-free phone conversation. Please use only a Panasonic KX-TCA60, KX-TCA86, KX-TCA88, KX-TCA88HA, KX-TCA91, KX-TCA92, or KX-TCA98 headset. To order, call the accessories telephone number on section 1-A. Connecting an optional headset Open the headset jack cover, and insert the headset plug into the headset jack as shown below. Headset Jack · Headset sold separately. To switch to the speakerphone while using the headset: Press [SP-PHONE]. To return to the headset, press [ ]. For assistance, please call: 1-800-211-PANA(7262) 4 1 Things You Should Know 4-F Base Unit Location/Noise 1 4-E Wall Mounting This unit can be mounted on a wall phone plate. Press the tabs in the direction of the arrows (#), then remove the wall mounting adaptor ($). 1 Calls are transmitted between the base unit and handset using wireless radio waves. · You are too far from the base unit. Walk closer to the base unit and try again. · Confirm the AC adaptor is plugged in. · If the above remedies do not solve the problem, the handset may have lost communication with the base unit. · Move the handset and the base unit away from other electrical appliances (4-F). [. . . ] When you leave the unit unused for a long period of time, unplug the AC adaptor from the outlet. · If there is any trouble--disconnect the unit from the telephone line and connect a known working phone. If the known working phone operates properly, have your unit repaired by one of the authorized Panasonic Factory Service Centers. If the known working phone does not operate properly, consult your telephone company. For your future reference Serial No. (found on the bottom of the unit) Date of purchase Name and address of dealer For assistance, please call: 1-800-211-PANA(7262) 5 1 Guía rápida Conecte como se muestra. Asegure el cable del adaptador de CA. [. . . ]