User manual PANASONIC KXTCD150AR

[. . . ] To use this unit in your country, first change the unit's region setting to match your country (page 29). Change the unit's display language as needed (page 16). (For Czech and Slovakia) This cordless telephone is possible to use according to General licence No. : VO-R/8/08. 2005-23 (for Czech), VPR-7/2001 (for Slovakia). TG6511-6521FX(e). book Page 2 Wednesday, February 24, 2010 1:41 PM Table of Contents Introduction Model composition . 5 Answering System Answering system . [. . . ] "Daily" An alarm sounds daily at the set time. Go to step 4. 1 2 3 4 5 8 i {#}{1}{0}{4} Enter the desired name (max. i M 2 times {ic} 3 4 5 Enter the desired date and month. i M {V}/{^}: Select the desired alarm tone. i M L We recommend selecting a different ringer tone from the one used for outside calls. M i {ic} L When the alarm is set, E is displayed. Changing the unit's region setting/Resetting the base unit 1 8 i {#}{1}{3}{6} 2 {V}/{^}: Select the desired country. iM 6 countries except Czech and Slovakia Czech Slovakia 3 {V}/{^}: "Yes" i M i {ic} Note: L To stop the alarm, press any dial key or place the handset on the base unit or charger. L When the handset is in use, the alarm will not sound until the handset is in standby mode. Note: L The following items will be deleted or reset to their default settings: ­ SMS settings (page 27) ­ Answering system settings (KX-TG6521, page 26) ­ Time Adjustment 29 TG6511-6521FX(e). book Page 30 Wednesday, February 24, 2010 1:41 PM Programming ­ Base unit ringer volume (KX-TG6521) ­ Base unit transmission power ­ Privacy mode ­ Base unit PIN ­ Dial mode ­ All SMS messages ­ Caller list ­ Voice mail messages L The following items will be retained: ­ Date and time ­ Handset name ­ Repeater mode ­ Recordings, including your greeting message and caller messages (KX-TG6521) ­ Call screening (KX-TG6521) ­ Call barred list (KX-TG6521) L If you select the desired country in step 2, the following default settings will be changed for the selected country's default settings: ­ Recall/flash time (page 26) ­ Display language (page 26) ­ Message centre 1 and 2 (page 27) ­ SMS on/off (page 27) L According to your country selection in step 2, the answering system announcement language changes as follows (KX-TG6521): Incoming call barring (Caller ID subscribers only) Available for: KX-TG6521 This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call. Important: L When the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list (page 33) with 7 after the call is disconnected. Storing unwanted callers You can store up to 30 phone numbers in the call barred list by using the caller list or by entering the numbers directly. i M i {ic} Note: L After turning the repeater mode on or off, _ is displayed on the handset momentarily. This is normal and the handset can be used once w is displayed. 1 2 3 8 i {#}{1}{3}{1} L All handsets registered to the base unit are displayed. {V}/{^}: Select the handset you want to cancel. i M {V}/{^}: "Yes" i M L A confirmation tone sounds. L The handset does not beep when cancelling its own registration. {ic} 4 Increasing the range of the base unit You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Contact your Panasonic dealer for details. Important: L Before registering the repeater to this base unit, you must turn the repeater mode on. L Do not use more than one repeater at a time. Setting the repeater mode 1 32 8 i {#}{1}{3}{8} TG6511-6521FX(e). book Page 33 Wednesday, February 24, 2010 1:41 PM Caller ID Service Using Caller ID service Important: L This unit is Caller ID compatible. [. . . ] Confirm that the correct SMS message centre numbers are stored. Confirm that SMS is turned on (page 35). L An error occurred while sending the message. L Your phone number is permanently withheld or you have not subscribed to the appropriate service. [. . . ]