User manual PANASONIC KX-TCD960

[. . . ] Digital Cordless Answering System Model No. KX-TCD970E-B KX-TCD960E-B Operating Instructions KX-TCD970E-B KX-TCD960E-B PLEASE READ BEFORE USE AND SAVE. Charge the battery for about 3 hours before initial use. This equipment is not designed for making emergency telephony calls when the power fails. Alternative arrangements should be made for access to emergency services. Important Information APPROVED for connection to telecommunication systems specified in the instructions for use subject to the conditions set out in them. 19) DTMF tone remote control system 20) Memo recording feature 21) Monitoring a telephone call 22) LCD call-counter: to indicate received messages 23) Vox facility: detection of caller's hanging up 24) Selecting the number of rings 1­7/AUTO 25) Auto disconnect 26) Total recording time (including the greeting message) is about 15 minutes 27) Security code for remote operation 28) Keypad dialling, use as integrated telephone (KX-TCD970E-B only) 29) Full handsfree operation (KX-TCD970E-B only) KX-TCD970E-B: 608759 KX-TCD960E-B: 608760 Do not connect the AC adaptor to any AC outlet other than the standard AC 230­240 V, 50 Hz. · Output voltage DC1 8 V, 500 mA Output voltage DC2 9 V, 200 mA · The apparatus is approved for use with the KX-TCA11E power supply. [. . . ] The indicator light goes out and "Answer off" is heard. · You can also turn on the answering system remotely using any other phone (p. 69). Monitoring incoming calls While a call is being recorded, you can monitor it through the speaker. To answer the call with the speakerphone, press (Digital speakerphone) (KX-TCD970E-B only). The unit stops recording. 59 Listening to Messages You can see the total number of recorded messages on the base unit display. If the ANSWER ON indicator light flashes, new messages have been recorded. Listening to only the new messages Press (New message) briefly. · The unit announces the number of new messages and plays them back. To increase the volume, press (Volume) . During playback, the display shows the message number. Listening to all of the recorded messages Press and hold (New message) firmly until a short beep sounds. Memo Button Repeat/Rew Button Skip/FF Button Stop Button At the end of the last message, "End of final message" is heard. After the announcement, the unit will automatically turn the answering system back on. New Message Button ANSWER ON Button and Indicator Flash Memory Message Backup Messages are stored indefinitely on a "flash memory" IC chip ­ even if a power failure occurs. All of the messages are saved until you erase them. 60 During playback To repeat/rewind the message To repeat from the beginning of the message Press (Repeat/Rew) briefly. · If you press within 5 seconds of playback, the previous message will be played. To rewind part of the message Press and hold (Repeat/Rew) until you reach the desired place. · At the beginning of the message, 3 beeps will sound. Answering System To skip/cue the message To skip to the next message Press (Skip/FF) briefly. To cue to part of the message Press and hold (Skip/FF) until you reach the desired place. · At the end of the message, 3 beeps will sound. · To resume playback, press (New message). To turn on the answering system, press ANSWER . To stop the operation Chapter 4 Recording a Memo Message You may record a personal message in memory. 1 Press beep(Memo). 2 After the beep, talk clearly about 20 cm away from thetime. · The base unit display shows the elapsed recording 3 When finished, press · A beep sounds. (Stop). 61 Erasing Messages The unit will announce the remaining recording time after playback, if it is less than 5 minutes. New messages cannot be recorded when: ­ "Memory is full. " is heard. ­ The number of messages displayed on the base unit flashes rapidly. ­ The ANSWER ON indicator light flashes rapidly. [. . . ] Advantages of DECT Excellent voice quality: Through sampling of digital signals DECT-units obtain nearly noiseless transmission. High grade tapping security: Based on digital transmission DECTconversations are well protected against unauthorised monitoring. Multi-Handset operation: There is no cable installation necessary when several handsets are operating at the base units. Interlink: Intercom conversations can be held free of charge between the registered handsets. [. . . ]