User manual PANASONIC KXTG1073NL

[. . . ] 6 Answering System Answering system . 39 Turning the answering system on/off 39 Greeting message . 40 Listening to messages using the base unit . 40 Listening to messages using the handset. [. . . ] 01289 8333 TG6591E(e). book Page 27 Friday, August 20, 2010 9:29 AM Distress Call L While the distress call is being dialled, your pre-recorded distress message is also played back from your speaker. Important: L You should include the information to press {1} to accept the call other than distress request and your name and address. Example: This is distress call from Mary Smith. Recording the distress message L When the distress call feature is turned on, speed dial key {III} lights up on all registered handsets and base unit. Note: L If you set the distress call feature to "On", speed dial cannot be used to call the number assigned to speed dial key {III}. 1 2 3 8 i {#}{2}{6}{6} {V}/{^}: "Yes" i M After a beep sounds, hold the handset about 20 cm away and speak clearly into the microphone (20 seconds max. ). {ic} Making a distress call using speed dial key {III} Important: L You should perform a test run of the distress call procedure (page 25). Handset Press and hold speed dial key {III}. L If the base unit is stored to the distress list, the base unit pages all handsets. Note for handset and base unit: L Speed dial key {III} flashes rapidly and your pre-recorded distress message is played back repeatedly from your speaker. L The unit dials out the distress number list in order (from 1st to 4th number). L After the other party accepts the call by pressing {1}, you can start to talk with the other party. *2 This feature allows the unit to automatically adjust the date and time each time caller information including date and time is received. To turn this feature on, select "Caller ID". To turn this feature off, select "Manual". (Caller ID subscribers only) To use this feature, set the date and time first (page 16). *3 When the ringer volume is turned off, ~ is displayed and the handset does not ring for outside calls. However even when the ringer volume is set to off, the handset still rings for alarm (page 33), intercom calls (page 46), and paging (page 46). *4 If you select one of the melody ringer tones, the ringer tone continues to play for several seconds even if the caller has already hung up. You may either hear a dial tone or no one on the line when you answer the call. *5 The preset melodies in this product are used with permission of © 2009 Copyrights Vision Inc. *6 Turn this feature off if you prefer not to hear key tones while you are dialling or pressing any keys, including confirmation tones and error tones. *7 If you subscribe to a Caller ID service and want to view the caller's information after lifting up the handset to answer a call, turn off this feature. [. . . ] Cause/solution L Disconnect the AC adaptor and telephone line cord from the base unit. Remove the batteries from the handset and leave to dry for at least 3 days. After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. [. . . ]