User manual PANASONIC KXTG1100FR

[. . . ] Please access our online customer survey: http://panasonic. net/pcc/tel/q TG7521E(e). book Page 2 Friday, January 22, 2010 8:46 AM Table of Contents Introduction Model composition . . 36 36 37 38 Important Information For your safety . 8 Answering System Answering system . 40 Turning the answering system on/off 40 Greeting message . [. . . ] L To cancel a selected category, press t again. M i {ic} 3 Note: L You can also select the categories in step 2 as follows: Press {1} to {9}. i M Changing the handset name Each handset can be given a customised name ("Bob", "Kitchen", Helpline Tel. 01289 8333 29 TG7521E(e). book Page 30 Friday, January 22, 2010 8:46 AM Programming From the caller list: 3 1 2 3 4 1 2 3 {<} (y) {V}/{^}: Select the entry to be barred. i M i I {V}/{^}: "Caller Barred" i M {V}/{^}: "Yes" i M i {ic} 1 i {#}{2}{1}{7} i m Enter the phone number (24 digits max. ). {ic} Enter the new 4-digit base unit PIN. i M i {ic} Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to a single base unit. Important: L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. Additional base units Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when "Auto" is selected on base unit (page 31), it looks for another base unit to make or receive calls. L When you purchase an additional handset, refer to the additional handset's installation manual for registration. Selecting a base unit When "Auto" is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. If the handset is out of range of that base unit, no calls can be made. Cancelling a base unit A handset can cancel a base unit that it is registered to. This allows the base unit to end its wireless connection with the system. 1 2 3 1 i {#}{1}{3}{9} {V}/{^}: Select the base unit you want to cancel. i M {V}/{^}: "Yes" i M i {ic} Note: L To register a handset to another base unit or to the same base unit again, see page 30. Increasing the range of the base unit You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Contact your Panasonic dealer for details. 1 1i {#}{1}{3}{7} Helpline Tel. 01289 8333 31 TG7521E(e). book Page 32 Friday, January 22, 2010 8:46 AM Programming Important: L Before registering the repeater to this base unit, you must turn the repeater mode on. L Do not use more than one repeater at a time. Setting the repeater mode 1 2 1 i {#}{1}{3}{8} {V}/{^}: Select the desired setting. [. . . ] Turn it on (page 44). I cannot operate the answering system remotely. 56 Helpline Tel. 01289 8333 TG7521E(e). book Page 57 Friday, January 22, 2010 8:46 AM Useful Information Liquid damage Problem Liquid or other form of moisture has entered the handset/base unit. Cause/solution L Disconnect the AC adaptor and telephone line cord from the base unit. Remove the batteries from the handset and leave to dry for at least 3 days. [. . . ]