User manual PANASONIC KXTG1313FR

[. . . ] To use this unit in your country, first change the unit's region setting to match your country (page 32). Change the unit's display language as needed (page 15). (For Czech and Slovakia) This cordless telephone is possible to use according to General licence No. : VO-R/8/08. 2005-23 (for Czech), VPR-7/2001 (for Slovakia). TG8511_8521FX(e-e). book Page 2 Wednesday, April 14, 2010 5:58 PM Table of Contents Introduction Model composition . 42 Answering System Answering system . [. . . ] i M L We recommend selecting a different ringer tone from the one used for outside calls. 31 TG8511_8521FX(e-e). book Page 32 Wednesday, April 14, 2010 5:58 PM Programming 3 Enter the desired hour and minute you wish to start this feature. i M L You can select 24-hour or 12hour clock format ("AM" or "PM") by pressing /. 2 {V}/{^}: Select your desired categories. i t L "Q" is displayed next to the selected category numbers. L To cancel a selected category, press t again. "Q" disappears. 4 Enter the desired hour and minute you wish to end this feature. i M 3 M i {ic} 5 {ic} L When the night mode is set, 3 is displayed. Note: L To correct a digit, press {<} or {>} to move the cursor to the digit, then make the correction. Changing the start and end time Note: L You can also select the categories in step 2 as follows: Press {1} to {9}. i M Changing the handset name Each handset can be given a customised name ("Bob", "Kitchen", etc. ). This is useful when you make intercom calls between handsets. You can also select whether or not the handset name is displayed in standby mode. "Q" disappears. 4M 5 {V}/{^}: Select a memory location. iM Changing the base unit PIN (Personal Identification Number) Important: L If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, contact an authorised service centre. 6 Enter the phone number or area code to be restricted (8 digits max. ). i M i {ic} L To erase a restricted number, press ^. Note: L You can also select a memory location in step 5 as follows: Press {1} to {6}. i M 1 1 (centre of navigator key) i {#}{1}{3}{2} 34 TG8511_8521FX(e-e). book Page 35 Wednesday, April 14, 2010 5:58 PM Programming 1 Handset: Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to a single base unit. Important: L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. Additional base units Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when "Auto" is selected on base unit (page 36), it looks for another base unit to make or receive calls. A base unit and the handsets it communicates with is called a "radio cell". [. . . ] Confirm that the correct SMS message centre numbers are stored. Confirm that SMS is turned on (page 39). L An error occurred while sending the message. L Your phone number is permanently withheld or you have not subscribed to the appropriate service. [. . . ]