User manual PANASONIC KX-TG2550B

[. . . ] For assistance, visit our website: http://www. panasonic. com/phonehelp for customers in the U. S. A. or Puerto Rico. Table of Contents Introduction Introduction. 8 Listening to messages using the handset . 50 Preparation Setting up the base unit . [. . . ] Important: L The setting should stay at 700 ms unless pressing {FLASH} fails to pick up the Call Waiting call. 1 2 3 {MENU} (center of joystick) i h i {SELECT} "Set tel line" i {SELECT} "Set line mode" i {SELECT} For assistance, please visit http://www. panasonic. com/phonehelp 41 Programmable Settings 4 Select the desired setting. (Default: "B") i {SAVE} i {OFF} Base unit 1 2 3 4 {MENU} i h i {SET} "Set tel line" i {SET} "Set line mode" i {SET} Select the desired setting. (Default: "B") i {SET} i {STOP} Changing the PIN (personal identification number) ^ For security, the PIN must be entered when changing certain settings such as registering units. The default setting is "7262". Important: L If you change the PIN, please make note of your new PIN. The unit does not reveal the PIN to you. Note: L The following items are reset to their default settings: ­ Settings indicated by "*2" in the feature column on page 81 ­ Answering system: On L If you have registered a cellular phone, the following cellular phone settings are also reset to their default settings. ­ "Assign Base/HS" (Allows you to select which unit to ring for cellular calls, page 59): "All" ­ "TAD (cell)" (Answering system for cellular phone, page 59): "Off" ­ "TAD ring count" (Ring count of answering system for cellular phone, page 60): "4 rings" Customer support Y ^ The handset and base unit can display the Internet address where you can download the operating instructions or get further information for this product using your computer. Handset 1 2 3 {MENU} i h i {SET} "Set PIN" i {SET} To change the PIN for the first time, skip to step 4. To change the PIN, enter the current 4digit PIN. i {SET} Enter the new 4-digit PIN again. i {SET} i {STOP} 1 2 3 1 2 3 {MENU} (center of joystick) i h i {SELECT} "Customer support" i {SELECT} L The Internet address is displayed. L Messages are retained even if a power failure occurs. Recording your greeting message ^ You can record your own greeting message (max. 2 minutes) that is played when the answering system answers a call. 1 2 3 4 5 1 {GREETING REC} "Greeting record" i {SET} After the base unit beeps, speak clearly about 20 cm (8 inches) away from the MIC. Press {STOP} when finished. Playing back the greeting message Press {GREETING CHECK}. 44 For assistance, please visit http://www. panasonic. com/phonehelp i Answering System 2 3 1 2 3 4 "Greeting check" i {SET} {STOP} Erasing your greeting message Press {GREETING CHECK}. "Greeting check" i {SET} Press {ERASE} while your greeting message is playing. {STOP} Listening to messages using the base unit When new messages have been recorded, the MESSAGE indicator on the base unit flashes. L The base unit plays new messages including memo messages. L When you have no new messages, the base unit plays back all messages. Adjusting the speaker volume Press {^} or {V} while listening to a message. Pre-recorded greeting message If you erase or do not record your own greeting message, the unit can play a prerecorded greeting message for callers and ask them to leave messages. If the message recording time (page 51) is set to "Greeting only", caller messages are not recorded and the unit plays a different prerecorded greeting message asking callers to call again. Useful features during playback ^ Repeating a message Press {<}. L If pressed within the first 5 seconds of a message, the previous message will be played. L To stop playback completely, press {STOP} again. [. . . ] When shipping the unit carefully pack, include all accessories, and send it prepaid, adequately insured and preferably in the original carton. Include a letter detailing the complaint and provide a day time phone number where you can be reached. IF REPAIR IS NEEDED DURING THE LIMITED WARRANTY PERIOD THE PURCHASER WILL BE REQUIRED TO FURNISH A SALES RECEIPT/PROOF OF PURCHASE INDICATING DATE OF PURCHASE, AMOUNT PAID AND PLACE OF PURCHASE. CUSTOMER WILL BE CHARGED FOR THE REPAIR OF ANY UNIT RECEIVED WITHOUT SUCH PROOF OF PURCHASE. For assistance, please visit http://www. panasonic. com/phonehelp 79 Useful Information Limited Warranty Limits And Exclusions This Limited Warranty ONLY COVERS failures due to defects in materials or workmanship, and DOES NOT COVER normal wear and tear or cosmetic damage. [. . . ]