User manual PANASONIC KX-TG5471

[. . . ] TG5471. fm Page 1 Monday, December 20, 2004 5:21 PM 5. 8 GHz Digital Cordless Answering System Operating Instructions Model No. KX-TG5471 Pulse-or-tone dialing capability The unit is Caller ID compatible. To display the caller's name and phone number, you must subscribe to Caller ID service. PLEASE READ BEFORE USE AND SAVE. Charge the battery for 6 hours before initial use. Panasonic World Wide Web address: http://www. panasonic. com for customers in the USA or Puerto Rico TG5471. fm Page 2 Monday, December 20, 2004 5:21 PM Thank you for purchasing your new Panasonic cordless telephone. Please read the IMPORTANT SAFETY INSTRUCTIONS on page 86 before use. [. . . ] 45), you can be informed of incoming calls by two tones. If this feature is turned on, incoming call tones will be heard for as long as the line is ringing. If this feature is set to "2", incoming call tones will be heard only 2 times. If this feature is turned off, no tones will be heard. Using the handset, this feature can be set separately for the handset and base unit. Preparation Handset incoming call tone Handset 1 Press [MENU]. 2 Press the soft key ( SELECT ) at "Ringer setting". Ringer setting Incoming call. Incoming call Telephone System 3 Scroll to "Incoming call. " by pressing [d] or [B], then press the soft key ( SELECT ). [B]. 4 Select "On", "Off" or "2" by pressing [d] or 5 Press the soft key ( SAVE ), then press [OFF]. Base unit incoming call tone Handset 1 Press [MENU]. 2 Scroll to "Initial setting" by pressing [d] or [B], then press the soft key ( SELECT ). or [B], then press the soft key ( SELECT ). tone :2 Answering System Initial setting Set base unit Incoming call. 3 Scroll to "Set base unit" by pressing [d] 4 Scroll to "Incoming call. " by pressing [d] or [B], then press the soft key ( SELECT ). [B]. Useful Information 5 Select "On", "Off" or "2" by pressing [d] or 6 Press the soft key ( SAVE ), then press [OFF]. Incoming call tone :2 For assistance, please call: 1-800-211-PANA(7262) 53 TG5471. fm Page 54 Monday, December 20, 2004 5:21 PM Special Features Key Tone Handset You can select whether or not the handset keys will sound tones (key tone, confirmation tone, error tone). The factory preset is ON. 1 Press [MENU]. 2 Scroll to "Initial setting" by pressing [d] or [B], then press the soft key ( SELECT ). Initial setting Key tone Key tone 3 Scroll to "Key tone" by pressing [d] or [B], then press the soft key ( SELECT ). 4 Select "Off" or "On" by pressing [d] or [B]. 5 Press the soft key ( SAVE ), then press [OFF]. :On 54 TG5471. fm Page 55 Monday, December 20, 2004 5:21 PM Special Features Re-registering the Handset Handset & Base Unit If "No link to base. Move closer to base and try again. " is displayed even when using the handset near the base unit, the handset may have lost communication with the base unit. You need to re-register the handset to that base unit. Make sure the base unit is not being used. Have both the handset and base unit nearby during registration. Preparation 1 Handset: Press [MENU]. 2 Handset: Scroll to "Initial setting" by pressing [d] or [B], then press the soft key ( SELECT ). Initial setting Telephone System 3 Handset: Scroll to "Registration" by pressing [d] or [B], then press the soft key ( SELECT ). Registration 4 Base unit: Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds. · The CHARGE indicator flashes. After the CHARGE indicator starts flashing, the rest of the procedure must be completed within 1 minute. 5 Handset: (1) Press the soft key ( O K ). (2) Wait until a long beep sounds and the display shows the following. · Registration is complete. Press LOCATOR on base unit for 3 sec. Then press OK BOX 1 IN USE BOX 2 OK Answering System Handset [1] Registered · You can stop registration by pressing [OFF] on the handset and pressing [LOCATOR/INTERCOM/TRANSFER] on the base unit. SPIPRIVACY1[2] Useful Information Important: Do not register other handsets to this base unit. [. . . ] If the problem is not handled to your satisfaction, then write to the warrantor's Consumer Affairs Department at the addresses listed for the warrantor. PARTS AND SERVICE, WHICH ARE NOT COVERED BY THIS LIMITED WARRANTY, ARE YOUR RESPONSIBILITY. Customer Services Directory Obtain Product Information and Operating Assistance; locate your nearest Dealer or Servicenter; purchase Parts and Accessories; or make Customer Service and Literature requests by visiting our Web Site at: http://www. panasonic. com/consumersupport or, contact us via the web at: http://www. panasonic. com/contactinfo You may also contact us directly at: 1-800-211-PANA (7262), Monday-Friday 9 am-9 pm; Saturday-Sunday 10 am-7 pm, EST. For hearing or speech impaired TTY users, TTY : 1-877-833-8855 Accessory Purchases Purchase Parts, Accessories and Instruction Books online for all Panasonic Products by visiting our Web Site at: http://www. pasc. panasonic. com or, send your request by E-mail to: npcparts@us. panasonic. com You may also contact us directly at: 1-800-332-5368 (Phone) 1-800-237-9080 (Fax Only) (Monday - Friday 9 am to 8 pm, EST. ) Panasonic Services Company 20421 84th Avenue South, Kent, WA 98032 (We Accept Visa, MasterCard, Discover Card, American Express, and Personal Checks) For hearing or speech impaired TTY users, TTY : 1-866-605-1277 Service in Puerto Rico Panasonic Puerto Rico, Inc. 9. 5, Carolina, Puerto Rico 00985 Phone (787)750-4300, Fax (787)768-2910 92 TG5471. fm Page 93 Monday, December 20, 2004 5:21 PM Specifications N Handset Power Supply: Frequency: Ni-MH battery (3. 6 V, 830 mAh) 5. 76 GHz ­ 5. 84 GHz (8 21/32" x 2 3/32" x 1 15/32") Mass (Weight): Security Codes: Approx. [. . . ]