User manual PANASONIC KX-TG6431

[. . . ] To use this unit in your country, first change the unit's region setting to match your country (page 29). Change the unit's display language as needed (page 15). (For Czech and Slovakia) This cordless telephone is possible to use according to General licence No. : VO-R/8/08. 2005-23 (for Czech), VPR-7/2001 (for Slovakia). TG661x_662xFX(e). book Page 2 Wednesday, March 2, 2011 2:31 PM Table of Contents Introduction Model composition. 38 Listening to messages using the base unit . [. . . ] *13The recall/flash time depends on your telephone exchange or host PBX. *14The default setting will be as follows if you select the following regional codes when changing the unit's region setting (page 29): *15To prevent other users from joining your conversations with outside callers, turn this feature on. Note: L To stop the alarm, press {ic} or place the handset on the base unit or charger. L When the handset is in use, the alarm will not sound until the handset is in standby mode. Special programming Alarm An alarm sounds at the set time for 3 minutes once or daily. Important: L Set the date and time beforehand (page 15). Night mode Night mode allows you to select a period of time during which the handset will not ring for outside calls. This feature is useful for time periods when you do not want to be disturbed, for example, while sleeping. Important: L Set the date and time beforehand (page 15). L We recommend turning the base unit ringer off (page 25) in addition to turning the night mode on. (KX-TG6621) L If you have set the alarm, the alarm sounds even if the night mode is turned on. 1 2 8(72) {r}: Select the desired alarm option. "Once" An alarm sounds once at the set time. "Daily" An alarm sounds daily at the set time. s M 2 times {ic} Viewing/editing/erasing bar call numbers 1 2 3 8(217 {r}: Select the desired entry. To edit a number: ~ s Edit the phone number. s M s {ic} To erase a number: W s {r}: "Yes" s M s {ic} Incoming call barring (Caller ID subscribers only) This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. Note: L When editing, press the desired dial key to add, ^ to erase. 28 TG661x_662xFX(e). book Page 29 Wednesday, March 2, 2011 2:31 PM Programming Setting call restriction You can restrict selected handsets from dialling certain numbers. You can assign up to 6 phone numbers to be restricted, and select which handsets are to be restricted. Storing area codes here prevents the restricted handsets from dialling any phone number in that area code. Changing the unit's region setting/Resetting the base unit 1 8(136 2 {r}: Select the desired country. s M 1 2 3 8(256 Enter the base unit PIN (default: "0000"). L If you forget your PIN, contact an authorised service centre. {r}: Select the handsets to be restricted. st L All handsets registered to the base unit are displayed. L "Q" is displayed next to the selected handset numbers. L To cancel a selected handset, press t again. [. . . ] L If you use a DSL/ADSL service, we recommend connecting a DSL/ADSL filter between the base unit and the telephone line jack. Contact your DSL/ADSL provider for details. L The unit could not connect to the SMS message centre. Confirm that the correct SMS message centre numbers are stored. [. . . ]