User manual PANASONIC KX-TG6432

[. . . ] ­ the cordless camera pages the handset when it detects sound (page 11). ­ the cordless camera user pages the handset using the call button (page 11). General L Use only the AC adaptor included with this product. L Do not connect the AC adaptor to any AC outlet other than a standard 220­240 V AC outlet. [. . . ] Symbols used in these operating instructions ­ while you are on a call with the handset. (In this case you will hear 2 tones and z will flash on the handset. With a handset, you can monitor the image and sound of the room where the cordless camera is located. The monitored camera does not ring, allowing you to easily monitor a baby's room, for example, from different areas of the house. Important: L Before you start monitoring, confirm that the camera lens of the cordless camera has been adjusted to the correct angle. l Only 1 person can access the cordless camera at a time. L A refreshed image taken by the cordless camera is displayed every few seconds. The displayed image is not a moving picture. L While monitoring a cordless camera, other users cannot make an intercom call or transfer a call. l The monitoring connection is automatically cancelled after 10 minutes. L While monitoring you cannot place the handset on the base unit or charger. With a handset, you can set the camera settings while monitoring. V To turn the feature on, push the joystick up. Push the joystick up or down to select the desired sensitivity. L To turn this feature off, push down the joystick repeatedly. L To return to the original view, press A again. Note: L When you turn this feature off, the cordless camera cannot detect sound (page 11). L To set the appropriate level, test the sensor of the camera from the handset beforehand. Using a handset registered to the same base unit, you can cancel the registration of a registered cordless camera. If for some reason the cordless camera is not registered to the base unit, register the cordless camera. Base unit: Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds. (program) on the back side of the cordless camera with a pointed object such as a pen until a beep sounds. [. . . ] A Slide the cordless camera into the wall-mounting adaptor in the direction of the arrow until it clicks into the place. B Tuck the call button wire into the hole on the side of the wall-mounting adaptor by plugging the small wire fixture into the hole. Drive the screws (not included) into the wall at a recommended height of 1. 8 m or below using the wall mount template as a guide (page 16). [. . . ]