User manual PANASONIC KX-TG6442

[. . . ] For your future reference Attach or keep original receipt to assist with any repair under warranty. (found on the bottom of the base unit) Date of purchase Name and address of dealer To use this product in Czech or Slovakia, change the unit's region setting (page 41) to match your country. Note: L In the event of problems, you should contact your equipment supplier in the first instance. Declaration of Conformity: L Panasonic Communications Co. , Ltd. [. . . ] Important: L To use automatic route selection, you must: ­ subscribe to the telephone carrier service you use ­ store the carrier codes you use ­ store the area codes you want to call using a specific carrier code ­ assign a carrier code to each stored area code Contact your telephone carrier(s) for calling rates. Example: You have assigned carrier code "9876" to area code "123". If you dial "123-4567", the unit dials "9876123-4567". 3 4 5 6 7 "Call Options" i # "ARS Settings" i # "Carrier Code" i # "On" i # Select a carrier code location (C1 to C5). i# L If the location already contains a carrier code, the code is displayed. i # i {ih} 8 Enter the carrier code (7 digits max. ). Storing area codes for ARS Store the area codes which should be dialled using a specific carrier. You can store up to 25 area codes. 1 " (centre of joystick) i n i # 2 Enter the base unit PIN (default: "0000"). 3 4 5 6 "Call Options" i # "ARS Settings" i # "Area Code" i # Select an area code location (1 to 25). i# L If the location already contains an area code, the code is displayed. # 7 Enter an area code (5 digits max. ). i 8 Select a carrier code you stored (C1 to C5) earlier. i # i {ih} L This carrier code will be automatically dialled when you make a call to this area code. 39 TCD820FX(e-e). book Page 40 Tuesday, September 13, 2005 9:10 AM n Base Unit Settings Turning ARS off 1 " (centre of joystick) i n i # 2 Enter the base unit PIN (default: "0000"). Storing/changing emergency numbers If you have set the call restriction feature (page 40) but want to allow a number to be dialled that would normally be restricted by call restriction, store the number as an emergency number. 3 4 5 6 "Call Options" i # "ARS Settings" i # "Carrier Code" i # "Off" i # i {ih} 1 " (centre of joystick) i n i # 2 Enter the base unit PIN (default: "0000"). Setting call restriction You can restrict selected handsets from dialling certain numbers. You can assign up to 6 phone numbers to be restricted, and select which handsets will be restricted. Nearby activated infrared devices may cause interference. Important: L Place the devices about 20 cm from each other, with their infrared ports pointing at each other. L Make sure there are no obstructions between the two devices. L Pictures larger than 176 (height) x 144 (width) pixels cannot be displayed. 4 Handset 1: "1 Entry" i # L To send all entries, select "All Entries". i # 5 Handset 1: Select the desired entry. i @ Handset 2 (receiver): c L When receiving more than one entry, "Incoming data. Add all entries to phonebook?" is displayed. Press # to save all entries. 6 To copy another entry: Handset 1: Repeat step 5. 42 TCD820FX(e-e). book Page 43 Tuesday, September 13, 2005 9:10 AM o Infrared Handset 2 (receiver): Select "Receive", press #, then repeat step 5. L To play the melody, select "Play Melody". i # 7 Handset 1 and Handset 2 (receiver): {ih} Note: L The copying all entries feature may not be supported by your GSM phone. 6 Handset 1 and Handset 2 (receiver): {ih} Note: L Melodies copied from GSM phones may sound different from the original when played on the handset. Copying saved pictures 1 Handset 1 and Handset 2 (receiver): " (centre of joystick) i o i # 2 Handset 1: "Send" i # Handset 2 (receiver): "Receive" i # 3 Handset 1: "User Pictures" i # 4 Handset 1: Push the joystick up or down to select the desired item. i # 5 Handset 2 (receiver): "Save Picture" i # L To see the picture, select "View Picture". [. . . ] Cause & solution L The following picture and melody formats are supported: Pictures: JPEG (176 (height) x 144 (width) pixels max. , about 50 KB) Melodies: MIDI (about 40 KB), iMelody L Melodies copied from a GSM phone may sound different from the original when played on the handset. L Melodies copied from your PC using a USB cable may sound different from the original when played on the handset. Connect the handset to your PC using an audio cable and record the melody (page 31). The melody sounds different from the original. 70 TCD820FX(e-e). book Page 71 Tuesday, September 13, 2005 9:10 AM Useful Information Specifications Standard: DECT (Digital Enhanced Cordless Telecommunications), GAP (Generic Access Profile) Number of channels: 120 Duplex Channels Frequency range: 1. 88 GHz to 1. 9 GHz Duplex procedure: TDMA (Time Division Multiple Access) Channel spacing: 1, 728 kHz Bit rate: 1, 152 kbit/s Modulation: GFSK (Gaussian Frequency Shift Keying) RF transmission power: Approx. 250 mW Voice coding: ADPCM 32 kbit/s Power source: 220­240 V, 50 Hz Power consumption, Base unit: Standby: Approx. [. . . ]