User manual PANASONIC KX-TG6461E

[. . . ] TG6461E(e). book Page 1 Monday, March 16, 2009 8:50 AM Operating Instructions Digital Cordless Answering System Model No. KX-TG6461E Thank you for purchasing a Panasonic product. You must subscribe to the appropriate service offered by your service provider/telephone company. Charge the batteries for about 7 hours before initial use. Please read these operating instructions before using the unit and save them for future reference. TG6461E(e). book Page 2 Monday, March 16, 2009 8:50 AM Table of Contents Introduction Accessory information. [. . . ] i 8 {V}/{^}: "Add Bar List" i M {b} 1 2 3 4 8 (middle soft key) {V}/{^}: "Caller Barred" i M {V}/{^}: Select the desired entry. Editing a number: 8 i {V}/{^}: "Edit" i M i Edit the phone number. i M i {ih} Erasing a number: W i {V}/{^}: "Yes" i M i {ih} By entering phone numbers: 8 (middle soft key) {V}/{^}: "Caller Barred" i M i ~ Enter the phone number (24 digits max. ). {b} Y Handset From the caller list: Note for base unit and handset: L When editing, press the desired dial key to add, ^ to erase. 1 2 3 4 5 1 2 3 4 8 (middle soft key) {V}/{^}: "Caller List" i M {V}/{^}: Select the entry to be barred. i 8 {V}/{^}: "Add Bar List" i M {ih} 8 (middle soft key) {V}/{^}: "Caller Barred" i M i ~ Enter the phone number (24 digits max. ). {ih} Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to the base unit. Important: L The additional handset model recommended for use with this unit is noted on page 3. If another handset model is used, certain operations (base unit settings, handset settings, etc. ) may not be available. By entering phone numbers: Viewing/editing/erasing bar call numbers = Base unit Registering a handset to the base unit The supplied handset and base unit are preregistered. If for some reason the handset is not registered to the base unit (for example, w flashes even when the handset is near the base unit), reregister the handset. 1 2 3 4 8 (middle soft key) {V}/{^}: "Caller Barred" i M {V}/{^}: Select the desired entry. Editing a number: 8 i {V}/{^}: "Edit" i M i Edit the phone number. i M i {b} 1 2 3 Handset: 8 (middle soft key) {V}/{^}: "Handset Setup" i M {V}/{^}: "Register H. set" i M Helpline Tel. 01289 8333 25 TG6461E(e). book Page 26 Monday, March 16, 2009 8:50 AM Programming 4 Base unit: Press and hold {x} for about 5 seconds, until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. L The next step must be completed within 90 seconds. Handset: Wait until "Base PIN" is displayed. i Enter the base unit PIN (default: "0000"). i M L If you forget your PIN, see page 42. L When the handset has been registered successfully, w stops flashing. Increasing the range of the base unit You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 3. Contact your Panasonic dealer for details. Important: L Before registering the repeater to this base unit, you must turn the repeater mode on. L Do not use more than one repeater at a time. [. . . ] Remove the batteries from the handset and leave to dry for at least 3 days. After the base unit/handset are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. If the unit does not work properly, contact an authorised service centre. Caution: L To avoid permanent damage, do not use a microwave oven to speed up the drying process. 44 Helpline Tel. [. . . ]