User manual PANASONIC KX-TG6461FX

[. . . ] TG6451_6461FX(e-e). book Page 1 Monday, May 4, 2009 8:55 AM Operating Instructions Digital Cordless Phone Model No. KX-TG6451FX KX-TG6461FX Digital Cordless Answering System Model No. Model shown is KX-TG6451. Thank you for purchasing a Panasonic product. You must subscribe to the appropriate service offered by your service provider/telephone company. Charge the batteries for about 7 hours before initial use. To use this unit in your country, first change the unit's region setting to match your country (page 25). [. . . ] "Daily" An alarm sounds daily at the set time. Go to step 7. 1 2 3 4 5 8 (middle soft key) {V}/{^}: "Base Unit Setup" i M {V}/{^}: "Base Unit PIN" i M Enter the current 4-digit base unit PIN (default: "0000"). i M i {ih} Changing the unit's region setting/Resetting the base unit Y Handset 6 7 8 Enter the desired date and month. i M {V}/{^}: Select the desired alarm tone. i M L We recommend selecting a different ringer tone to the one used for outside calls. M i {ih} L When the alarm is set, E is displayed. 1 2 3 4 8 (middle soft key) {V}/{^}: "Base Unit Setup" i M {V}/{^}: "Country" i M {V}/{^}: Select the desired country. i M countries except Czech and Slovakia Czech Ceská rep. Slovakia 9 5 {V}/{^}: "Yes" i M i {ih} Note: L You can skip to step 4 by pressing {R/E} in standby mode. L To stop the alarm, press any dial key or place the handset on the charger. L When the handset is in use, the alarm will not sound until the handset is in standby mode. L If you select "Once", the setting changes to "Off" after the alarm sounds. Note: L The following items will be deleted or reset to their default settings: ­ Base unit settings (page 22, 24) ­ Answering system settings (KX-TG6461, page 34) ­ Time Adjustment ­ Caller list ­ Voice mail messages ­ Ringer setup (Base unit, page 22) L The following items will be retained: ­ Date and time ­ Repeater mode 25 TG6451_6461FX(e-e). book Page 26 Monday, May 4, 2009 8:55 AM Programming ­ Recordings, including your greeting message and caller messages (KX-TG6461) ­ Call screening (KX-TG6461) ­ Call barred list L If you select the desired country in step 4, the following default settings will be changed for the selected country's default settings: ­ Display language (page 22, 23) L According to your country selection in step 4, the answering system announcement language changes as follows (KX-TG6461): = Base unit From the caller list: 1 2 3 4 1 2 3 4 \ (right soft key) {V}/{^}: Select the entry to be barred. i 8 {V}/{^}: "Add Bar List" i M {b} 8 (middle soft key) {V}/{^}: "Caller Barred" i M i ~ Enter the phone number (24 digits max. ). {b} By entering phone numbers: - "Other" - English Czech Slovak L After changing the unit's region setting/resetting the base unit, certain icons displayed on the base unit disappears for a moment and w flashes on the handset momentarily. This is normal and the handset can be used once w stops flashing. Y Handset From the caller list: Incoming call barring (Caller ID subscribers only) This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call. Program this setting using either the base unit or one of the handsets. Important: L When the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list (page 29) with 7 after the call is disconnected. Storing unwanted callers You can store up to 30 phone numbers in the call barred list by using the caller list or by entering the numbers directly. Important: L It is advised to store the phone number with an area code in the call barred list. 1 2 3 4 5 1 2 3 4 8 (middle soft key) {V}/{^}: "Caller List" i M {V}/{^}: Select the entry to be barred. i 8 {V}/{^}: "Add Bar List" i M {ih} 8 (middle soft key) {V}/{^}: "Caller Barred" i M i ~ Enter the phone number (24 digits max. ). {ih} By entering phone numbers: Viewing/editing/erasing bar call numbers = Base unit 1 2 3 4 8 (middle soft key) {V}/{^}: "Caller Barred" i M {V}/{^}: Select the desired entry. [. . . ] L Edit the phonebook entry name to fit in 1 line of text (page 18). Caller information is displayed late. The name stored in the phonebook is not displayed fully while an outside call is being received. 45 TG6451_6461FX(e-e). book Page 46 Monday, May 4, 2009 8:55 AM Useful Information Answering system (KX-TG6461) Problem The unit does not record new messages. Cause/solution L The answering system is turned off. L The recording time is set to "Greeting Only". [. . . ]