User manual PANASONIC KX-TG6621E

[. . . ] TG6611-6621E(e). book Page 1 Tuesday, December 7, 2010 2:00 PM Operating Instructions Digital Cordless Phone Model No. KX-TG6611E KX-TG6612E KX-TG6613E KX-TG6621E KX-TG6622E KX-TG6623E KX-TG6624E Digital Cordless Answering System Model No. Model shown is KX-TG6611. Before initial use, see "Getting Started" on page 11. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. You must subscribe to the appropriate service offered by your service provider/telephone company. Please access our online customer survey: http://panasonic. net/pcc/tel/q TG6611-6621E(e). book Page 2 Tuesday, December 7, 2010 2:00 PM Table of Contents Introduction Model composition. [. . . ] L When the handset is in use, the alarm will not sound until the handset is in standby mode. Night mode Night mode allows you to select a period of time during which the handset will not ring for outside calls. This feature is useful for time periods when you do not want to be disturbed, for example, while sleeping. Important: L Set the date and time beforehand (page 16). L We recommend turning the base unit ringer off (page 25) in addition to turning the night mode on. (KX-TG6621/KX-TG6622/ KX-TG6623/KX-TG6624) L If you have set the alarm, the alarm sounds even if the night mode is turned on. Changing the handset name Each handset can be given a customised name ("Bob", "Kitchen", etc. ). This is useful when you make intercom calls between handsets. You can also select whether or not the handset name is displayed in standby mode. If you select "Yes" without entering any handset name, "Handset 1" to "Handset 6" is displayed. Turning night mode on/off 1 2 3 4 5 8(1)4 Enter the desired name (max. s M 2 times {ic} 1 2 3 8(238 {r}: Select the desired setting. s M L If you select "Off", press {ic} to exit. Enter the desired hour and minute you wish to start this feature. s M L You can select 24-hour or 12-hour clock format ("AM" or "PM") by pressing /. Enter the desired hour and minute you wish to end this feature. s M {ic} L When the night mode is set, 3 is displayed. 4 5 Incoming call barring (Caller ID subscribers only) This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call. Important: L When the unit receives a call from a number that is stored in the call barred list, the call is Changing the start and end time 1 2 8(237 Continue from step 3, "Turning night mode on/off", page 27. Helpline Tel. 01289 8333 27 TG6611-6621E(e). book Page 28 Tuesday, December 7, 2010 2:00 PM Programming logged in the caller list (page 30) with 7 after the call is disconnected. 2 3 Enter the base unit PIN (default: "0000"). {r}: Select the handsets to be restricted. st L All handsets registered to the base unit are displayed. L "Q" is displayed next to the selected handset numbers. L To cancel a selected handset, press t again. [. . . ] Cause/solution L Disconnect the AC adaptor and telephone line cord from the base unit. Remove the batteries from the handset and leave to dry for at least 3 days. After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. [. . . ]