User manual PANASONIC KX-TG7434

[. . . ] 35 Voice Mail Service Voice mail service. 37 Important Information For your safety . 38 Transferring calls, conference calls . 38 Useful Information Character entry. [. . . ] (Caller ID subscribers only) To use this feature, set the date and time first (page 14). *3 When the ringer volume is turned off, ~ is displayed and the handset does not ring for outside calls. However even when the ringer volume is set to off, the handset still rings for alarm (page 26), intercom calls (page 38), and paging (page 38). *4 If you select one of the melody ringer tones, the ringer tone continues to play for several seconds even if the caller has already hung up. You may either hear a dial tone or no one on the line when you answer the call. *5 The preset melodies in this product are used with permission of © 2007 Copyrights Vision Inc. *6 Turn this feature off if you prefer not to hear key tones while you are dialling or pressing any keys, including confirmation tones and error tones. *7 If you subscribe to a Caller ID service and want to view the caller's information after lifting up the handset to answer a call, turn off this feature. *8 The recall/flash time depends on your telephone exchange or host PBX. *9 To prevent other users from joining your conversations with outside callers, turn this feature on. Helpline Tel. 01289 8333 25 TG5521E(e). book Page 26 Tuesday, March 16, 2010 7:47 AM Programming Special programming Alarm An alarm sounds at the set time for 3 minutes once or daily. Important: L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. By entering phone numbers: Viewing/editing/erasing bar call numbers 1 2 3 8 i {#}{2}{1}{7} {V}/{^}: Select the desired entry. To edit a number: ~ i Edit the phone number. i M i {ic} To erase a number: W i {V}/{^}: "Yes" i M i {ic} Registering a handset to the base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, _ is displayed even when the handset is near the base unit), reregister the handset. Note: L When editing, press the desired dial key to add, ^ to erase. 1 2 Handset: 8 i {#}{1}{3}{0} Base unit: Press and hold {x} for about 5 seconds, until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. Then repeat this step. Changing the base unit PIN (Personal Identification Number) Important: L If you change the PIN, please make note of your new PIN. 01289 8333 27 TG5521E(e). book Page 28 Tuesday, March 16, 2010 7:47 AM Programming L The next step must be completed within 90 seconds. Contact your Panasonic dealer for details. Important: L Before registering the repeater to this base unit, you must turn the repeater mode on. L Do not use more than one repeater at a time. [. . . ] Turn it on (page 35). My own greeting message cannot be properly heard. I cannot operate the answering system. I cannot operate the answering system remotely. 46 Helpline Tel. 01289 8333 TG5521E(e). book Page 47 Tuesday, March 16, 2010 7:47 AM Useful Information Liquid damage Problem Liquid or other form of moisture has entered the handset/base unit. Cause/solution L Disconnect the AC adaptor and telephone line cord from the base unit. [. . . ]