User manual PANASONIC KX-TG8062E

[. . . ] TG8051_8061E(e). book Page 1 Monday, January 24, 2011 4:37 PM Operating Instructions Digital Cordless Phone Model No. KX-TG8051E KX-TG8061E KX-TG8062E KX-TG8063E Digital Cordless Answering System Model No. Model shown is KX-TG8051. Before initial use, see "Getting Started" on page 11. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. You must subscribe to the appropriate service offered by your service provider/telephone company. Please access our online customer survey: http://panasonic. net/pcc/tel/q TG8051_8061E(e). book Page 2 Monday, January 24, 2011 4:37 PM Table of Contents Introduction Model composition. [. . . ] Go to step 4. Turning night mode on/off 3 4 5 Enter the desired date and month. s M L We recommend selecting a different ringer tone from the one used for outside calls. M s {ic} L When the alarm is set, z is displayed. 1 2 3 1 (middle soft key) (238 {r}: Select the desired setting. s M L If you select "Off", press {ic} to exit. Enter the desired hour and minute you wish to start this feature. s M L You can select 24-hour or 12-hour clock format ("AM" or "PM") by pressing /. Enter the desired hour and minute you wish to end this feature. s M {ic} L When the night mode is set, f is displayed. 6 4 5 Note: L To stop the alarm, press {ic} or place the handset on the base unit or charger. L When the handset is in use, the alarm will not sound until the handset is in standby mode. Changing the start and end time 1 1 (middle soft key) (237 28 Helpline Tel. 0844 844 3898 Ireland 01289 8333 TG8051_8061E(e). book Page 29 Monday, January 24, 2011 4:37 PM Programming 2 Continue from step 3, "Turning night mode on/off", page 28. 4 5 {r}: Select the desired setting. s M 2 times {ic} Setting the ring delay This setting allows the handset to ring during night mode if the caller waits long enough. After the selected amount of time passes, the handset rings. If you select "No Ringing", the handset never rings during night mode. 1 1 (middle soft key) (239 2 {r}: Select the desired setting. s M s {ic} Note: L When the answering system answers the call, this feature does not work. (KX-TG8061/KX-TG8062/KX-TG8063) Incoming call barring (Caller ID subscribers only) This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call. Important: L When the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list (page 32) with 7 after the call is disconnected. Selecting categories to bypass night mode 1 2 1 (middle soft key) (241 {r}: Select your desired categories. s t L "Q" is displayed next to the selected category numbers. L To cancel a selected category, press t again. M s {ic} Storing unwanted callers You can store up to 30 phone numbers in the call barred list. [. . . ] After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. If the unit does not work properly, contact an authorised service centre. Caution: L To avoid permanent damage, do not use a microwave oven to speed up the drying process. Helpline Tel. 0844 844 3898 Ireland 01289 8333 47 TG8051_8061E(e). book Page 48 Monday, January 24, 2011 4:37 PM Useful Information Belt clip To attach To remove Wall mounting Note: L Make sure that the wall and the fixing method are strong enough to support the weight of the unit. [. . . ]