User manual PANASONIC KX-TG8622E

[. . . ] TG862xE(e). book Page 1 Thursday, March 17, 2011 11:40 AM Operating Instructions Premium Digital Telephone with built in Answering System and TFT Colour Display Model No. KX-TG8621E KX-TG8622E KX-TG8623E Model shown is KX-TG8621. Before initial use, see "Getting Started" on page 10. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. This unit is compatible with Caller ID and SMS. You must subscribe to the appropriate service offered by your service provider/telephone company. [. . . ] s ~sm Enter the desired name (16 characters max. ; page 59). s M Enter the desired number (24 digits max. ). s M 2 times L "Baby Monitor" will be displayed. Note: L The registered name/number is displayed. Turning off the baby monitor The monitored handset cannot be used while baby monitor is set to "On". Baby monitor sensitivity You can adjust the sensitivity of the baby monitor. Increase or decrease the sensitivity to adjust the sound level needed to trigger the baby monitor feature. L This feature cannot be set during a monitoring call. 1 2 3 Press 1 on the handset being monitored. {r}: "Sensitivity Level" s M Press {^} or {V} to select the desired setting. s M s {ic} 1 2 3 Press 1 on the handset being monitored. {r}: "On/Off" s M {r}: "Off" s M s {ic} Editing an outside monitoring number 1 2 3 4 5 Press 1 on the handset being monitored. {r}: "On/Off" s M {r}: "On" s M {r}: Select the outside line. s ~ 1 s {r}: "Edit" s M Note: L When the baby monitor is activated, you cannot access the direct commands using the monitored handset. Before setting the baby monitor feature, you can use direct commands to adjust baby monitor sensitivity (page 26). Helpline Tel. 0844 844 3898 Ireland 01289 8333 35 TG862xE(e). book Page 36 Thursday, March 17, 2011 11:40 AM Programming Answering the baby monitor When monitoring with a handset: Press {C} to answer calls. If you want to respond from the monitoring handset, press 1. L The monitoring handset will answer calls automatically when the auto intercom feature is set to "On" (page 53). Note: L If you receive an outside call when communicating with the monitored handset, you hear 2 tones. To answer the call, press {ic}, then press {C}. When monitoring from an outside line: To answer a call, follow the operation for your phone. If you want to respond from the monitoring handset, press (1 using tone dialling. You can turn off the baby monitor feature by pressing (). Note: L 2 minutes after the monitored handset starts a call, communication between the monitored handset and monitoring phone line is turned off automatically. Important: L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations may not be available. [. . . ] Remove the batteries from the handset and leave to dry for at least 3 days. After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. If the unit does not work properly, contact an authorised service centre. Caution: L To avoid permanent damage, do not use a microwave oven to speed up the drying process. Wall mounting Note: L Make sure that the wall and the fixing method are strong enough to support the weight of the unit. [. . . ]