User manual PANASONIC KX-TGA914EX

[. . . ] This cordless camera is an accessory unit for use with Panasonic Digital Cordless Phone: KX-TG9120/KX-TG9140/KX-TG9150 You must register this cordless camera with your base unit before it can be used. Please read these Operating Instructions before using the unit and save for future reference. 7 Symbols used in these operating instructions . For your future reference Attach or keep original receipt to assist with any repair under warranty. [. . . ] Important: L Before you start monitoring, confirm that the camera lens of the cordless camera has been adjusted to the correct angle. l Only 1 person can access the cordless camera at a time. L A refreshed image taken by the cordless camera is displayed every few seconds. The displayed image is not a moving picture. L While monitoring a cordless camera, other users cannot make an intercom call or transfer a call. l The monitoring connection is automatically cancelled after 10 minutes. L While monitoring you cannot place the handset on the base unit or charger. the monitoring connection will be cancelled. L The cordless camera may not page handsets in the following conditions: ­ when other users are on an intercom or conference call. ­ when electrical interference is emitted from electrical devices. When you finish monitoring, press {ih} or place the handset on the base unit or charger. Talking to the paged party using the cordless camera When the cordless camera is paged from a handset, the cordless camera does not ring and the speakerphone is turned on. (It detects sound or its call button is pressed. L You can monitor the room where the camera is located. Handset: When you finish monitoring, press {ih} or place the handset on the base unit or charger. The cordless camera can page handsets when it detects sound or by pressing its call button. Then the answering handset user can monitor live images from the cordless camera. Important: L Only registered handsets can be paged from the cordless camera. L If a handset is paged by the cordless camera during a call, 2 tones sound and z flashes on the handset. To monitor the cordless camera from the handset, press {ih}, then press {s}. L Auto intercom feature cannot be used when paged by a cordless camera. Paging using the camera audio sensor Important: L To use the audio detection feature of the cordless camera, turn the audio detection sensitivity to on (page 13). [. . . ] Mount the cordless camera (A), then slide it down (B) and to the right (C) until it is secure. Upside down mounting L The image may be seen upside down when mounting upside down. To compensate for this, change the cordless camera setting to display images upside down (page 9). Drive the screws (not included) into the wall at a recommended height of 1. [. . . ]