User manual PANASONIC KX-TGDA51

[. . . ] Failure to do so may cause electric shock and/or excessive heat resulting in a fire. From the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. R Unplug the product from power outlets if it emits smoke, an abnormal smell, or makes an unusual noise. [. . . ] To protect your privacy/confidentiality, we recommend that you erase information such as phonebook or caller list entries from the memory before you dispose of, transfer, or return the product. Setting up Connections/Wall mounting Connect the AC adaptor to the power outlet. Drive the screws (1) (not supplied) into the wall, if necessary. (It is normal for the adaptor to feel warm during use. ) R Make sure that the wall and the fixing method are strong enough to support the weight of the unit. battery installation/Battery charging Important: R Use the supplied rechargeable batteries. For replacement, we recommend using the Panasonic rechargeable batteries noted on page 2. R Confirm correct polarities ( , Charge for about 7 hours. r Confirm “Charging” is displayed (2). R When the batteries are fully charged, “Fully charged” is displayed. 4 2 3 2 1 1 Note: R If the batteries are fully charged, but the operating time seems to be shorter, clean the battery ends ( , ) and the charge contacts with a dry cloth and charge again. Removing the battery 1 2 For assistance, please visit http://shop. Pdf 5 2016/11/25 16:20:50 Installation Handset key print For the following function, the key prints are different for the supplied handset and optional handset. N KX-TGDA51: For KX-TGD510/KX-TGD530 series users Function Supplied handset MFLASHN MCALL WAITN Optional handset (KX-TGDA51) M M N*1/MFLASHN N*1/MFLASHN Flash Call waiting *1 The remote voice assist feature is only available for KX-TGD560 series. Function Supplied handset M N Optional handset (KX-TGDA50) MFLASHN/ MCALL WAITN n KX-TGDA50: For KX-TGD560 series users Remote voice assist Registering a handset to a base unit 1 Base unit: 2 Press and hold MLOCATORN for about 5 seconds. R If all registered handsets start ringing, press MLOCATORN again to stop, then repeat this step. Handset: Place the handset on the base unit or charger, then wait until a long beep is displayed. Sounds and Note: R If an error tone sounds, or if is displayed, register the handset according to the base unit’s operating instructions. Display language 1 MMENUN#110 2 MbN: Select the desired setting. Pdf 6 2016/11/25 16:20:50 Installation FCC and other information This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 68. When you hold the phone to your ear, noise might be heard in your Hearing Aid. Some Hearing Aids are not adequately shielded from external RF (radio frequency) energy. [. . . ] Product or Part Name Telephone Parts One (1) Year Labor One (1) Year During the “Labor” warranty period there will be no charge for labor. During the “Parts” warranty period, there will be no charge for parts. This Limited Warranty excludes both parts and labor for non-rechargeable batteries, antennas, and cosmetic parts (cabinet). This warranty only applies to products purchased and serviced in the United States. [. . . ]