User manual PANASONIC KX-TS17W

[. . . ] Call Waiting Caller ID, which displays a second caller's name and phone number while the user is on another call, requires a subscription to both Caller ID and Call Waiting. Attach your purchase receipt here. For your future reference Serial No. (found on the bottom of the unit) Date of purchase Name and address of dealer Accessories (included) For extra orders, call 1-800-332-5368. PQZHTC1481B one one one 2 For Best Performance Battery Charge A rechargeable Ni-Cd battery powers the handset. Charge the battery for about 15 hours before initial use (p. [. . . ] Tuck the telephone line cord inside the wall mounting adaptor, then push it in the direction of the arrow (1 and 2). The word "UP WALL" should face upward. 2 To Power Outlet 1 4 Connect the telephone line cord. Mount the unit, then slide down. Raise the antenna. Wall Phone Plate 28 5 To charge the battery: Fit the handset hole in the tab (1) and fix the charge contacts (2). Make sure to place the handset with the keypad facing down. 1 Hole Tab 2 Adding Another Phone This unit will not function during a power failure. To connect a standard telephone on the same line, use the Panasonic T-adaptor KX-J66. To order, call the accessories telephone number on page 2. Standard Telephone Useful Information Single-Line Telephone Jack Telephone Line Cord T-Adaptor (KX-J66) For assistance, please call: 1-800-211-PANA(7262) 29 Battery Replacement If "RECHARGE" and " " are displayed after a few telephone calls even if the battery was fully charged, replace the battery with a new Panasonic PQWBTC1461M (P-P504) battery. To order, call the accessories telephone number on page 2. 1 Press the notch on the handset cover firmly (1) and slide it as indicated by the arrow (2). 1 2 2 Remove the old battery. Then install the new one. Insert the battery plug into the connector as shown in the picture. Be sure wires are free from being pressed by the battery body or handset cover. Black Lead Red Lead 3 Close the cover. Make sure you charge the new battery for about 15 hours. A nickel cadmium battery that is recyclable powers the product you have purchased. Other electrical appliances connected to the same outlet may be interfering with the Caller ID information. Telephone line noise may be affecting the Caller ID information. Do not pause for over 60 seconds while searching. The display goes to the standby mode while viewing the Caller List. When a second call is The caller requested not to send his/her received during a information. conversation, the unit does not display the new caller's name and/or phone number. (HANDSET\LOCATOR) does not function. The handset is too far from the base unit. The handset is engaged in an outside call. Wait until the IN USE/CHARGE indicator light goes out. 32 Problem You cannot redial by pressing (PAUSE/REDIAL). Cause and Remedy When pressing (PAUSE/REDIAL) after (­­­/FLASH) , more than 32 digits long number will not be redialed correctly. When pressing (­­­/FLASH) after (PAUSE/REDIAL), more than 24 digits long number will not be redialed correctly. 8). "RECHARGE" and " " are displayed or the handset beeps intermittently. While talking, the call is disconnected. You charged the battery fully, but "RECHARGE" and " " are still displayed. The IN USE/CHARGE indicator light does not go out while charging. [. . . ] Parts One (1) Year Labor One (1) Year During the "Labor" warranty period there will be no charge for labor. During the "Parts" warranty period, there will be no charge for parts. You must mail-in your product during the warranty period. This Limited Warranty excludes both parts and labor for batteries, antennas, and cosmetic parts (cabinet). [. . . ]