User manual PANASONIC KX-TS710

[. . . ] L Connect the unit to a USB port on your computer. For optimum performance, do not connect more than one unit to a single computer or the unit to your computer via a hub. L The unit may not turn off and may consume electricity regardless of whether your computer is turned off or in sleep mode. By connecting/disconnecting the unit from an active computer, the unit will turn on/off. [. . . ] Cause/solution L The application software you want to use with the unit was started before installing the unit. please restart the application software. L The USB cable is not connected properly to the unit and your computer. L Make sure that your computer audio device's recording volume is set to the maximum. l If the status indicator is red , press {T} to turn the microphone-mute off. L The unit may not be selected as the audio device of your computer. L The unit may not work properly depending on the power supply of your computer's USB port. If this is the case and your computer has multiple USB ports, we recommend that you try other USB ports. L Unplug the USB cable from the computer and the unit, then reconnect it. If the status indicator is still flashing red, there may be a problem with the unit. contact the Panasonic service personnel. L Make sure the USB cable is properly connected to the unit and your computer. L Panasonic cannot accept any liability or provide warranty for security problems occurring in the following cases: ­ when the internet security settings were not set during use, ­ when VoIP (Voice over Internet Protocol) communication software was used. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. [. . . ] Telephone Accessory / Product - One (1) year LIMITATIONS AND EXCLUSIONS This warranty does not apply to products purchased outside Canada or to any product which has been improperly installed, subjected to usage for which the product was not designed, misused or abused, damaged during shipping, or which has been altered or repaired in any way that affects the reliability or detracts from the performance, nor does it cover any product which is used commercially. this warranty is extended to the original end user purchaser only. A purchase receipt or other proof of date of original purchase is required before warranty service is performed. In certain instances, some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, or the exclusion of implied warranties, so the above limitations and exclusions may not be applicable. [. . . ]