User manual PANASONIC KX-TVS200

[. . . ] L Avoid touching the battery ends (S, T) or the unit contacts. L USE ONLY Ni-MH batteries AAA (R03) size. L Do NOT use Alkaline/Manganese/Ni-Cd batteries. L When the batteries are fully charged, the charge indicator goes off. Rechargeable Ni-MH ONLY Confirm "Charging" is displayed. Note: L If the batteries are fully charged, but the operating time seems to be shorter, clean the battery ends (S, T) and the charge contacts with a dry cloth and charge again. For assistance, please visit http://www. panasonic. com/help 3 Controls A H A Charge indicator Ringer indicator Message indicator B Speaker C Soft keys D {C} (TALK) E {s} (SP-PHONE: Speakerphone) F Headset jack G Dial keypad ({*}: TONE) H Receiver I Display J {OFF} K Joystick L {FLASH} {CALL WAIT} M Microphone N Charge contacts I B C D E F G M N C J K L Registering a handset to a base unit 1 Base unit: NKX-TG6411 series Press and hold {LOCATOR} for about 4 seconds. [. . . ] Feature Intercom Initial setting Customer support *1 KX-TG6411 series *2 KX-TG6421/KX-TG6431/KX-TG6441/KX-TG7431 series The display mode can be switched temporarily or set by programming. N Switching temporarily: You can temporarily switch the display mode as follows by pressing the right soft key shown when viewing the lists or selecting menu icons: ­ {MULTI}: Multiple entries/all menu icons are shown on one screen at a time. ­ {SINGLE}: An entry/a menu icon is shown on one screen in large characters at a time. Note: L When "Multi items" is selected as the display mode, you can switch the screen to confirm the detailed information by pressing {SINGLE}. N By programming: You can set the unit to always show a single item or multiple items beforehand by selecting "Single item" or "Multi items" as the display mode setting. 8 For assistance, please visit http://www. panasonic. com/help Select the desired setting: ­ "Multi items": Multiple entries/all menu icons are shown on one screen at a time. ­ "Single item": An entry/a menu icon is shown on one screen in large characters at a time. The default setting is "Multi items". 1 {MENU} (center of joystick) i {#}{1}{9}{2} 2 {V}/{^}: Select the desired setting. i {SAVE} 3 {OFF} Note: L When {MULTI} or "Multi items" is selected as the display mode, you can move screens by pushing the joystick right or left, without scrolling down or up through the list: ­ Push the joystick right to go to the next screen. ­ Push the joystick left to return to the previous screen. Listening to messages using the handset Listening to messages from the message list You can select the item to play back. 1 {MENU} (center of joystick) i {#}{3}{2}{9} 2 {V}/{^}: Select the desired item from the message list. i {PLAY} L You can erase the selected message as follows: {ERASE} i {V}/{^}: "Yes" i {SELECT} 3 When finished, press {OFF}. Note: L If the item has already been heard, "Q" is displayed, even if it was heard using another handset. L If the unit cannot receive caller information, "Msg. " is displayed in the message list. The electrolyte is toxic and may be harmful if swallowed. L Exercise care when handling the batteries. Do not allow conductive materials such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit may cause the batteries and/or the conductive material to overheat and cause burns. L Charge the batteries provided with or identified for use with this product only, in accordance with the instructions and limitations specified in this manual. L Only use a compatible base unit (or charger) to charge the batteries. Do not tamper with the base unit (or charger). Failure to follow these instructions may cause the batteries to swell or explode. Attention: A nickel metal hydride battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY (1-800-8228837) for information on how to recycle this battery. Other information L Operating the product near electrical appliances may cause interference. Move away from the electrical appliances. L Use only the power cord and batteries indicated in this manual. [. . . ] WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO EMERGENCY NUMBERS: 1) Remain on the line and briefly explain to the dispatcher the reason for the call. 2) Perform such activities in the off-peak hours, such as early morning or late evenings. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ]