User manual PANASONIC KX-TVS90

[. . . ] Attach the plate with the 4 KX-TVS90 and a DPT into the screws (included). 4 holes on the plate (included). Document Version 2009-03 3 Wall Mounting CAUTION: Do not mount this unit on a wall while attached to a DPT. Doing so may damage the wall mounting adaptor or, may cause the unit to fall, possibly resulting personal injury. Remove the wall mounting adaptor from the unit as shown. [. . . ] Set the operation board to level 1, then connect and secure the telephone line cord. Attach the wall mounting adaptor as shown. · Make sure the cord is not pinched by the wall mounting adaptor. When running the cord from the top of the unit, look through the opening in the wall mounting adaptor (A) to confirm that the cord is not being pinched. 4. Drive the 2 screws (included) into the wall either 83 mm (3-1/4 in) or 100 mm (3-15/16 in) apart, and mount the unit on the wall. 83 mm (3-1/4 in) 100 mm (3-15/16 in) · You can find a wall mounting template on page 8. · Make sure that the wall that the unit will be attached to is strong enough to support the unit (approx. · Make sure the cord is securely fastened to the wall. · When this unit is no longer in use, make sure to detach it from the wall. Washer Drive the screw to this point. 4 Document Version 2009-03 Important Information When using a KX-TVS90 Digital DSS Console, keep the following conditions in mind. · If you are having problems making calls, unplug the extension line and connect a known working Digital DSS Console. If the known working DSS Console operates properly, have the defective DSS Console repaired by an authorized Panasonic factory service center. If the known working DSS Console does not operate properly, check the PBX and the internal extension wiring. Consult your authorized Panasonic dealer for detailed instructions. Important Safety Instructions When using this unit, basic safety precautions, including those below, should always be followed to reduce the risk of fire, electric shock and injury to persons. Do not use the unit near water, for example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Avoid using a wired telephone during an electrical storm. There is a remote risk of electric shock from lightning. Do not use a telephone in the vicinity of a gas leak to report the leak. SAVE THESE INSTRUCTION FCC Information F. C. C. REQUIREMENTS AND RELEVANT INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]