User manual PANASONIC KY-B617AF

[. . . ] Thank you for purchasing this Panasonic appliance. When electricity flows in the magnetic coils underneath the top plate, magnetic lines of force are produced. The magnetic lines of force pass through metallic cookware when an eddy current is induced. The heat that is generated by the electrical resistance of the cookware is used for heating. [. . . ] Note ■■ ■■ ■■ Cooking Timer can be used with Pan Frying Mode. (See page 27) The actual temperature at the base of the pan may vary from the set temperature depending on the type of cookware. Ensure that the cookware is dry inside and out before heating up. 24 EN IH Cooking English Deep/Shallow Frying Mode Available on the cooking zones with and . When deep/shallow frying, use Deep/Shallow Frying Mode ( ) with minimum 200 g oil at least 1 cm deep. Failure to observe this warning may cause oil to overheat resulting in a fire. Touch and hold the main power key to turn on the power. Place the pan with the required amount of oil on the cooking zone. Touch the sensor option key until shown. Touch slider to set the required temperature. When the set temperature is reached, the temperature display stops flashing and the appliance beeps 5 times. When the timer reaches “0”, the appliance beeps 5 times and turns off the cooking zone. Note Cooking Timer can not be set for Deep/Shallow Frying Mode. 27 EN IH Cooking Timer Using Kitchen Timer Used independently from all other cooking functions. Ouch and hold the main power key to turn on T the power. Touch Timer key to select Kitchen Timer. Kitchen Timer is selected automatically if the appliance is not in operation. Touch Timer key twice if the appliance is in operation. Kitchen Timer symbol flashes until the time is set. –■ Keep holding either ‘+’ or ‘-’ will increase or decrease hours or minutes rapidly. cancelling Kitchen Timer: ■■ Set the timer to “0”. Adjusting countdown time: ■■ Once countdown has started, the timer can be adjusted. [. . . ] ) If connecting to aluminium wiring, use connectors approved for use with aluminium wiring. Check with the local utilities for electrical codes applied in the area. Failure to wire the appliance according to governing codes may result in a hazardous condition. After installation, show the customer where the breaker for the appliance is located. [. . . ]