User manual PANASONIC KYB626SL

[. . . ] KY-B626SL KY-B626GL KY-B625GB KY-B615AB KY-R615AB FOR DOMESTIC USE ONLY NUR FÜR HAUSHALTSÜBLICHEN GEBRAUCH POUR UN USAGE DOMESTIQUE KY-B625GB IMPORTANT SAFETY INSTRUCTIONS: Before operating this appliance, please read these instructions carefully and keep for future reference. Before the installation: Before installing this appliance, write down the information below from the rating plate. The rating plate is on the bottom of the appliance. Thank you for purchasing this Panasonic appliance. [. . . ] Place the pan with the required amount of oil on the cooking zone. Touch the sensor option key until shown. When the set temperature is reached, the temperature display stops flashing and the appliance beeps 5 times. Touch and hold the key of the cooking zone or set the temperature to “OFF” to turn off the cooking zone. NOTE ■ ■ ■ Cooking Timer cannot be used with Deep/Shallow Frying Mode. (See page 28) The whole flex cooking zone cannot be used with Deep/Shallow Frying Mode. The actual oil temperature may vary from the set temperature depending on the cookware. 25 EN IH Cooking Deep/Shallow Frying Mode Observe the following to keep Genius Sensor functioning efficiently. 9 L) Depth: minimum 1 cm Place the pan in the centre of the cooking zone. Do not use hot oil, brown-coloured oil, cloudy oil, or oil with food sediment. Observe the recommendations for suitable cookware. (See pages 15-16) Ensure the top plate and bottom of the pan are dry and clean. Do not add ingredients before the temperature display stops flashing. heating may stop due to an abnormality detected. Once preheating has started, do not add oil or move the pan to another cooking zone. ■ ■ ■ ■ ■ ■ 26 EN IH Cooking English Timer Using Cooking Timer Used to switch a cooking zone off automatically. Cooking Timer can be set for multiple cooking zones. Touch and hold the main power key to turn on the power. Touch Timer key once to select Cooking Timer. Cooking Timer symbol flashes when the corresponding cooking zone is selected and until the timer is set. Touch slider to set the desired cooking time. – Timer can be set while the timer display is flashing. [. . . ] Connect the power cord in accordance with all governing codes and ordinances. – Single-phase connection (220-240 V ~ 50 Hz) Connect the wires in accordance with the instructions given in the following table and diagram: Electrical cable Wire connection : Yellow / Green (Connect to the earth terminal) N: Grey and Blue together L: Black and Brown together (Connect to the live terminal) N L ■ Three-phase connection (380-415 V 2N~ 50 Hz) Separate the L wires and connect them in accordance with the instructions given in the following table and diagram: Wire connection : Yellow / Green (Connect to the earth terminal) N: Grey and Blue together L1: Black L2: Brown (Connect to the live terminal) Electrical cable N L1 L2 48 EN Installing the Appliance WARNING Do not disassemble the top plate. Connected wire may become loose and cause a malfunction. Fasten the clamps to the appliance (2 places at rear). [. . . ]