User manual PANASONIC MC-E740

[. . . ] â· Do not vacuum water or other liquids. â· Keep the vacuum cleaner away from heat sources such as radiators, fires, direct sunlight, etc. â· This vacuum cleaner is fitted with a thermal cut-out device which automatically turns off the cleaner to prevent overheating of the motor. When this happens, disconnect the cleaner from the socket outlet and check the dust compartment and filters as they may be full or clogged with fine dust. [. . . ] check for any other obstructions in the hose or tube. After removing the obstruction, leave the cleaner to cool down until the thermal cut-out resets after approximately 60 minutes. A) B) C) D) E) F) G) H) I) J) K) L) Floor nozzle Connection pipe Hose Curved wand Extension wand Hose inlet Dust cover ON/OFF Switch / power control button Cord rewind pedal Plug Multipurpose accessory Paper dust bag C-1 C-2 Pull out the mains lead and put the plug into the socket outlet. Power control : OFF You can turn the appliance ON by turning it to the clockwise direction. To increase or decrease the power, turn the variable power control. (Only MC-CG381) C-3 Switching between carpet and flooring Flooring: Press lever A Carpet: Press lever B After you finish vacuuming, remove the plug from the socket outlet and press the cord rewind pedal. When rewinding the mains lead, press the cord rewind pedal holding the plug so that it does not become damaged. storage position Slide the wand holder straight into the wand supporter. Park position For short breaks during vacuuming, slide the wand holder into slot on the rear side of main body. Check whether the pre-motor filter is blocked with dust. If they are blocked, clean them out or replace them. D-1 D-2 D-3 D-4 Lift the dust cover catch and raise the dust cover until it clicks properly. Remove the bag collar from the bag holder and pull out the paper dust bag. Close the dust cover properly until you hear it click. Using an old toothbrush or similar tool, clean any dirt or lint from the brush. D-6 Wipe with a soft cloth soaked with water. The model and serial number of this product may be found on the nameplate located at the underside of your cleaner. You should note the model and serial number in the spaces provided and retain this book as a permanent record of your purchase. [. . . ] The model and serial number of this product may be found on the nameplate located at the underside of your cleaner. You should note the model and serial number in the spaces provided and retain this book as a permanent record of your purchase. Follow the procedure written below when the suction power is not restored after replacing a new paper dust bag. Wash gently with water and then allow to dry in a shaded location. [. . . ]