User manual PANASONIC MC-CL485K

[. . . ] The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED. Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter E or the Earth Symbol Before using the vacuum cleaner, please observe these basic precautions. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] â· Dusting brush Dusting brush is use for furniture, venetian blinds and bookshelves and have to be attached onto the crevice tool. Insert the curved wand and connection pipe into the hose supporter at each end of the hose until the projection clicks into the hole of the attachment. Insert the connection pipe into the hose inlet and turn it clockwise until it locks in place. To disconnect the hose, turn it counter-clockwise and then remove. Insert the curved wand into the upper end of the extension wand and the floor nozzle to the other end. (Only MC-CL481K, MC-CL483K) Insert the curved wand into the upper end of the extension wand until the round hole fit into the tab on the extension wand. (When removing the curved wand, push the tab down while pulling out the curved wand). IMPORTANT: To obtain the good performance of the vacuum cleaner, we encourage you to rotate the filter knob (R) for two complete cycles each time after finish vacuuming. The plug must be removed from the socket outlet before cleaning or maintaining the appliance. To avoid injury, keep your fingers and hands away from the beater bar. DO NOT use hot air or hot surface to dry filter. Keep at room temperature for approximately 24 hours. IMPORTANT : Before re-installing the washable filter, make sure they are completely dry to avoid damaging the cleaner. Maintaining the Pre-motor filter D - 13 Push the dust compartment buckle and pull up the dust compartment from the main body. If this happens, empty the dust compartment and check for possible dust trapped on the filters. D-1 Push the dust compartment buckle and pull up the dust compartment from the main body. Pull out the filter assembly from the dust compartment. What to do if your cleaner does not work D-4 D-5 Empty the dust compartment. Place back the filter assembly into the dust compartment. NOTE: Be sure to use the cleaner with the filter assembly at the dust compartment. [. . . ] Also available through our internet is direct shopping for a wide range of finished products, take a browse on our website for further details. This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your local retailer upon the purchase of an equivalent new product. [. . . ]